Paxar Monarch Sierra Sport4 9493 User Manual

Size:
149.52 Kb
Download

A C C E S S O R Y I N S T R U C T I O N S

These instructions describe how to use the following options for carrying the Monarch® Sierra Sport2™ 9460™ and Sierra Sport4™ 9493™ portable printers:

hip strap

clip

shoulder strap

hand strap

Information in this document supercedes information in previous versions. Check our Web site

(www.monarch.com) for the latest documentation and release information.

A t t a c h i n g t h e H i p S t r a p a n d C l i p

1. Put the hip strap on like a normal belt, inserting one side of the buckle into the other. The adjustment slide must face out.

Adjustment Slide

To loosen or tighten the hip strap, move the slide toward or away from the buckle.

TC9460ACPHOI Rev AF 10/07 ©2007 Paxar Americas, Inc. a subsidiary of Avery Dennison Corp. All Rights Reserved.

2. Press the end of the clip and slide it all the way over the hip strap or onto a piece of clothing. The slot on the clip must face out.

Slot

Clip

3. Lower the printer and slide the strap button into the slot on the outside of the clip until you feel it click into place.

Strap Button

9460 Printer

2

R e m o v i n g t h e H i p S t r a p a n d C l i p

1. Holding the printer with one hand, press the release switch with your other hand and lift the printer up and out of the clip.

2. To remove the hip strap, press the end of the release tabs and pull the other side of the buckle out.

Press release switch

Release Tabs

Pull this side out

3. Press the end of the clip and pull it away from the hip strap or the piece of clothing that you attached it to.

3

A t t a c h i n g t h e S h o u l d e r a n d H a n d S t r a p s

1. On both sides of the printer, place the loop over the strap button, and pull up gently. You will feel it click into place.

Adjustment

Piece

Loop and strap button.

2. To raise or lower the shoulder strap, move the adjustment slide toward or away from the end of the strap.

R e m o v i n g t h e S h o u l d e r S t r a p

On both sides of the printer, gently push down on the loop attached to the button and pull it away from the printer.

4