Paxar Four Station Charger 6094 User Manual

Size:
488.45 Kb
Download

6094 TM Four

Station Charger

Operating Instructions

TC6094OI Rev. BA 4/02

©2002 Paxar Corporation. All rights reserved.

Each product and program carries a respective written warranty, the only warranty on which the customer can rely. Monarch reserves the right to make changes in the product and the programs and their availability at any time and without notice. Although Monarch has made every effort to provide complete and accurate information in this manual, Monarch shall not be liable for any omissions or inaccuracies. Any update will be incorporated in a later edition of this manual.

WARNING

This equipment can interfere with radio communication if not installed and used in accordance with the instruction manual. It has been tested and found to comply with the limits for a

Class A computing device pursuant to FCC Rules, Part 15, Subpart B, which provide reasonable protection against such interference when operated in a commercial environment. Operation in a residential area is likely to cause interference which the user must correct at their own expense.

CANADIAN D.O.C. WARNING

This digital apparatus does not exceed the Class A limits for radio noise emissions from digital apparatus set out in the Radio Interference Regulations of the Canadian Department of Communications.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe A prescrites dans le Réglement sur le brouillage radioélectrique édicte par le ministère des Communications du Canada.

Trademarks

Monarch and PATHFINDER are registered trademarks of Monarch Marking Systems, Inc.

Paxar is a trademark of Paxar Corporation.

6094 is a trademark of Monarch Marking Systems, Inc.

IMPORTANT SAFETY INSTRUCTIONS

Save These Instructions

This manual contains important safety and operating instructions for the 6094 charger. Before using the 6094 charger, please read all instructions and caution markings on:

the charger.

the battery handle.

the printer.

WARNING

The 6094 charger is for charging PATHFINDER® battery handles only. Other types of battery handles may burst causing personal injury and damage.

General Safety Precautions

1.Do not expose the charger to rain or snow.

2.When disconnecting the power cord, pull on the plug, not the cord. Do not operate the charger with a damaged plug or cord----replacethe power cord immediately if damaged.

i

6094 Operating Instructions

3.Do not use an extension cord unless absolutely necessary.

If an extension cord is used, make sure

the wire is 18 gauge or larger.

the pins on the plug of the extension cord are the same number, size, and shape as those of the plug on the charger.

the extension cord is properly wired and in good electrical condition.

4.Do not operate the charger if it is damaged. Call Monarchâ Service.

5.Do not disassemble the charger. Incorrect reassembly may result in risk of electric shock or fire. Contact Monarch Service when service or repair is required.

6.To reduce risk of electric shock, unplug charger from outlet before doing any maintenance or cleaning. Turning the power off does not reduce this risk.

7.The plug for the charger is equipped with a grounding pin. The outlet for installation must be installed and grounded in accordance with all local codes and ordinances.

ii

Table of Contents

1.

Overview................................................................................

1

 

Charging Time................................................................

1

 

Convenience Features ...................................................

2

2.

Installing the Charger .........................................................

3

 

Setting the Power Supply ...............................................

3

 

Wall Mount Installation ...................................................

5

 

Power On Test ...............................................................

6

3.

Charging Handles ...............................................................

7

4.

Troubleshooting ..................................................................

9

 

Problems and Solutions .................................................

9

 

Replacing Fuses...........................................................

11

 

Specifications ...............................................................

12

iii

6094 Operating Instructions

iv

1. Overview

The 6094 charger is a "fast charge" accessory for charging and storing PATHFINDER battery handles. There are four charging stations on the charger. Each station charges independently, which means you can attach battery handles at anytime.

Charging Time

Charging time varies depending upon the capacity rating of the battery handle and its usage. Most battery handles will recharge in less than 2 hours.

NOTE: Battery handles with a higher capacity rating will take longer to charge.

With the 6094, you cannot damage the battery handles by overcharging. The 6094 automatically reduces power to a "trickle" charge to maintain the charge of the battery handle until it is removed.

1

6094 Operating Instructions

Convenience Features

Additional features are:

switchable power supply which lets you select 100, 120, 220, or 240 VAC for your operating area.

charging status indicator light for each charging station.

replaceable fuses.

Familiarize yourself with the different parts of the 6094 charger.

Power Light

Status

Indicator

Fuse Box

Charging

Power Station

Switch

2

2. Installing the Charger

The charger may be mounted to the wall or set on a sturdy table. Before installing the charger

set the power supply for the voltage in your area.

select a location for wall mounting or table top use.

perform the power on test.

Setting the Power Supply

When you first receive the charger, the power supply is factory pre-set:

6094-01is 120 VAC with 1A fuses.

6094-02is 220/240 VAC with .5A fuses.

6094-03is 100 VAC with 1A fuses.

To reset the power supply for 100, 120, 220, or 240 VAC:

1.Turn the power OFF.

2.Unplug the power cord.

3.Use the tip of a screwdriver or pen to open the fuse box as shown. The fuse box is located on the left side of the charger beside the power switch.

Fuse Box

3

6094 Operating Instructions

4.Carefully pull the fuse box straight out. Fuses are attached, so be careful not to drop or jolt the fuses.

CAUTION

Make sure you are using the correct fuses for the voltage you select.

5.Using a screwdriver, pull the power selector straight out.

Power

Selector

6.Rotate the power selector to the setting required.

7.Push the power selector all the way into the slot. Make sure the selected number is facing you.

8.Change all fuses to the correct fuses for the voltage selected. See "Replacing Fuses" in Chapter 4.

9.Replace the fuse box, pushing until it snaps closed.

4