R
Heavy Duty CD player/Weather Band Receiver
CQ-5301U
Operating Instructions
M
U
T
E
• Please read these instructions carefully before using this product and keep this manual for future reference.
Safety Information
Read the operating instructions for the unit and all other components of your car audio system carefully before using the system. They contain instructions about how to use the system in a safe and effective manner. Panasonic assumes no responsibility for any problems resulting from failure to observe the instructions given in this manual.
|
This pictograph intends to alert you to the |
|
|
presence of important operating instructions and |
|
Warning |
installation instructions. Failure to heed the |
|
instructions may result in severe injury or death. |
||
|
||
|
|
Warning
Observe the following warnings when handling this unit.
The driver should not operate the system while driving.
Operating the system will distract the driver from looking ahead of the vehicle and can cause accidents. Always stop the vehicle in a safe location and use the parking brake before operating the system.
Use the proper power supply.
This product is designed for operation with a negative grounded 12 V DC battery system. Never operate this product with other battery systems, especially a 24 V DC battery system.
Do not expose the unit to direct sunlight or excessive heat.
Otherwise these will raise the interior temperature of the unit, and it may lead to smoke, fire, or other damage to the unit.
Keep batteries out of reach of infants.
Batteries can be ingested, so keep them out of the reach of infants. If an infant ingests a battery, please seek immediate medical attention.
Do not use the product where it is exposed to water, moisture, or dust.
Exposure of the unit to water, moisture, or dust may lead to smoke, fire, or other damage to the unit. Make especially sure that the unit does not get wet in car washes or on rainy days.
Protect the Deck Mechanism.
Do not insert any foreign objects into the slot of this unit.
Do not disassemble or modify the unit.
Do not disassemble, modify the unit or attempt to repair the product yourself. If the product needs to be repaired, consult the shop where you purchased this unit or an authorized Panasonic Servicenter.
Do not use the unit when it is out of order.
If the unit is out of order (no power, no sound) or in an abnormal state (has foreign matter in it, is exposed to water, is smoking, or smells), turn it off immediately and consult the store where you purchased it.
The remote control unit should not lie about in the car.
If the remote control unit lies about, it could fall on the floor
2
This manual uses pictographs to show you how to use the product safely and to alert you to potential dangers resulting from improper connections and operations. The meanings of the pictographs are explained below. It is important that you fully understand the meanings of the pictographs in order to use this manual and the system properly.
|
This pictograph intends to alert you to the |
|
|
presence of important operating instructions and |
|
Caution |
installation instructions. Failure to heed the |
|
instructions may result in injury or material |
||
|
||
|
damage. |
while driving, get wedged under the brake pedal, and lead to a traffic accident.
Observe the following warnings when installation.
Disconnect the lead from the negative (–) battery terminal before installation.
Wiring and installation with the negative (–) battery terminal connected may cause electrical shock and injury due to a short circuit.
Some cars equipped with the electrical safety system have specific procedures of battery terminal disconnection.
FAILURE TO FOLLOW THE PROCEDURE MAY LEAD TO THE UNINTENDED ACTIVATION OF THE ELECTRICAL SAFETY SYSTEM RESULTING IN DAMAGE TO THE VEHICLE AND PERSONAL INJURY OR DEATH.
Never use safety-related components for installation, grounding, and other such functions.
Do not use safety-related vehicle components (fuel tank, brake, suspension, steering wheel, pedals, airbag, etc.) for wiring or fixing the product or its accessories.
Installing the product on the air bag cover or in a location where it interferes with airbag operation is prohibited.
Check for piping, gasoline tank, electric wiring, and other items before installing the product.
If you need to open a hole in the vehicle chassis to attach or wire the product, first check where the wire harness, gasoline tank, and electric wiring are located. Then open the hole from outside if possible.
Never install the product in a location where it interferes with your field of vision.
Never have the power cord branched to supply other equipment with power.
After installation and wiring, you should check the normal operation of other electrical equipment.
The continuation of their using in abnormal conditions may cause fire, electrical shock or a traffic accident.
In the case of installation to an airbag-equipping car, confirm warnings and cautions of the vehicle manufacturer before installation.
Make sure the leads do not interfere with driving or getting in and out of the vehicle.
CQ-5301U
Caution
Observe the following cautions when handling this unit.
Keep the sound volume at an appropriate level.
Keep the volume level low enough to be aware of road and traffic conditions while driving.
Do not insert or allow your hand or fingers to be caught in the unit.
To prevent injury, do not get your hand or fingers caught in moving parts or in the disc slot. Especially watch out for infants.
This unit is designed for use exclusively in automobiles.
Do not operate the unit for a prolonged period with the engine turned off.
Operating the audio system for a long period of time with the engine turned off will drain the battery.
Refer fuse replacement to qualified service personnel.
When the fuse burns out, eliminate the cause and have it replaced with the fuse prescribed for this unit by a qualified service engineer. Incorrect replacement of the fuse may lead to smoke, fire, and damage to the product.
Observe the following cautions when installation.
Refer wiring and installation to qualified service personnel.
Installation of this unit requires special skills and experience. For maximum safety, have it installed by the shop where you purchased it. Panasonic is not liable for any problems resulting from your own installation of the unit.
Follow the instruction to install and wire the product.
Not following the instructions to properly install and wire the product could cause an accident or fire.
Take care not to damage the leads.
When wiring, take care not to damage the leads. Prevent them from getting caught in the vehicle chassis, screws, and moving parts such as seat rails. Do not scratch, pull, bend or twist the leads. Do not run them near heat sources or place heavy objects on them. If leads must be run over sharp metal edges, protect the leads by winding them with vinyl tape or similar protection.
Use the designated parts and tools for installation.
Use the supplied or designated parts and appropriate tools to install the product. The use of parts other than those supplied or designated may result in internal damage to the unit. Faulty installation may lead to an accident, a malfunction or fire.
Do not block the air vent or the cooling plate of the unit.
Blocking these parts will cause the interior of the unit to overheat and will result in fire or other damage.
Do not install the product where it is exposed to strong vibrations or is unstable.
Avoid slanted or strongly curved surfaces for installation. If the installation is not stable, the unit may fall down while driving and this can lead to an accident or injury.
Installation Angle
The product should be installed in a horizontal position with the front end up at a convenient angle, but not more than 30˚.
The user should bear in mind that in some areas there may be restrictions on how and where this unit must be installed. Consult your dealer for further details.
CAUTION!
THIS PRODUCT UTILIZES A
USE OF CONTROLS OR PERFORMANCE OF PROCEDURES THOSE SPECIFIED HEREIN HAZARDOUS RADIATION
DO NOT OPEN COVERS
YOURSELF. REFER SERVICING TO QUALIFIED PERSONNEL.
The following applies only in the U.S.A.
Part 15 of the FCC Rules
FCC Warning:
Any unauthorized changes or modifications to this equipment would void the user's authority to operate this device.
Laser products:
Wave length: 790 nm
Laser power: No hazardous radiation is emitted with safety protection.
Accessories 2. |
Supplied Hardware............................................................................. |
1 set ( page 21) |
1. |
Operating Instructions .................................................................................................. |
1 |
3. |
Warranty Card............................................................................................................... |
1 |
3
CQ-5301U
Contents
Safety Information(Part 15 of the FCC Rules). . . . . . . . . . . . . . . . . Page 2
Accessories . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Power and Sound Controls . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Power, volume, mute, display change, audio mode
(Bass/Treble/Balance/Fader)
Clock Setting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Initial time, time reset
Radio . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . |
9 |
Radio mode, band, manual tuning, seek tuning, preset station setting, |
FM |
preset station calling, display change |
|
CD Player . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Disc insert and playback, stop and disc eject, listening to a CD, CD player mode, display change, track selection, track search, direct track selection, random play, scan play, repeat play,pause
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Troubleshooting tips, where to get service help
Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Care of the unit, notes on discs, notes on CD-Rs/RWs
Speaker Connections. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19
Installation Guide . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20
Installation hardware, overview, required tools dashboard specifications, identify all leads, connect all leads, final installation, final checks, preparation, to remove the unit
Electrical Connections . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
Cautions, wiring diagram
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 25
4
CQ-5301U
M U T
E
Radio
q Radio Mode
to change to the radio mode.
CD Player
( When CD disc loaded
)
FM stereo indicator, lights while receiving an FM stereo signal.
w Band
Press [BAND] to change the
FM1
AM
e Manual Tuning
[}TUNE]: Higher frequency [{TUNE]: Lower frequency
Seek Tuning
Press and hold for more than 0.5 seconds and release it. [}TUNE]: Higher frequency
[{TUNE]: Lower frequency
Tuning will automatically stop when the next broadcast station is received.
9
CQ-5301U
Loading...