GM950 User Guide
GM950 |
|
User Guide |
|
Contents |
|
|
Page: |
Safety Information ................................................. |
1 |
General Information.............................................. |
2 |
Radio Controls and Indicators .............................. |
2 |
Audio Signals........................................................ |
3 |
Display Icons ......................................................... |
3 |
Radio On/Off ......................................................... |
3 |
Channel Selection ................................................ |
4 |
4-Channel Model ............................................. |
4 |
128-Channel Model ......................................... |
4 |
Channel Without Selective Call Functions............ |
4 |
Communication Procedures ................................. |
4 |
Call Termination ............................................... |
4 |
Channel With Selective Call Functions................. |
5 |
Address Selection............................................ |
5 |
Status Selection............................................... |
5 |
Sending a Selective Call.................................. |
5 |
Receiving a Selective Call ............................... |
5 |
Option Button Functions....................................... |
6 |
Computer Software Copyright .............................. |
7 |
Every radio, when transmitting, radiates energy into the atmosphere which may, under certain conditions, cause the generation of a spark. All users of vehicles fitted with radios should be aware of the following warning:
WARNING: Do not operate radio near inflammable liquids or in the vicinity of explosive devices.
During normal use, the radio will subject you to radio energy substantially below the level where any kind of harm is reported.
To ensure personal safety, please observe the following simple rules:
■DO NOT transmit when the antenna is very close to, or touching, exposed parts of the body, especially the face and eyes.
■DO NOT hold the transmit (PTT) key in when not actually desiring to transmit.
■DO NOT allow children to play with any radio equipment containing a transmitter.
■DO NOT operate radio whilst driving. It should also be noted that the use of a hand-held microphone while driving could constitute an offence under Road Traffic Regulations.
|
|
Contents/Safety Information 1 |
English |
|
|
||
|
|
|
|
|
|
|
|
General Information
Congratulations on choosing the GM950, an excellent mobile radio. Motorola’s stringent quality procedures guarantee the high standard of Motorola products. Your radio has left our factory only after extensive tests.
This user guide describes the way a standard radio works. Since standard operation may be changed by programming, the way your radio operates may differ slightly from what is described here.
If in doubt contact the person in charge of your radio system or the Motorola dealer who supplied the equipment.
WARNING: When installing or removing the mobile radio from the vehicle, the radio must be switched off.
The numbers refer to the illustrations on the inside front cover.
1.Radio ON/OFF.
2.Microphone connector.
3.Volume Up/Down Control.
4.Three LED Indicators:
Red, continuous: Radio transmits
Red, flashing: |
Channel busy |
Yellow, continuous: |
Monitor mode |
Yellow, flashing: |
Radio Called |
Green, continuous: |
Function button enabled |
|
(non-display radio only) |
Green, flashing: |
Scanning on |
Red, Green: |
Error indication. Switch |
(alternating) |
radio off then on again. |
Red, Yellow, Green: |
If error indication |
(alternating) |
persists,return radio to |
|
dealer. |
5.Squelch Button.
6.Programmable Function Button.
7.Channel Selection Buttons.
8.Channel Selected LEDs.
9.Programmable Option Buttons.
10.LCD Display.
Three characters + Function Icons.
11.Microphone PTT (Push To Talk).
English |
2 General Information/Radio Controls and Indicators |
|
|
Audio Signals
High pitched tone Medium pitched tone
Power Up - Radio self-test
OK
Power Up - Radio self-test
Fail
Button Error
Force Monitor
Keypad Acknowledge
Channel Busy Tone
Individual Call Alert
Individual Call Reminder
Group Call Alert
TOT Pre Alert
Monitor Alert
Scan Start
Priority Channel
Volume Select
H/W error - Button press not accepted, tone continues until valid operation.
The icons which appear on the display are:
Scan Enabled
Monitor Enabled
Repeater Talkaround/Call Forward Enabled
External Alarm Enabled
Multicall 1-Address Selection Mode S Multicall 2-Status Selection Mode Channel Selection Mode
Coded/Clear - Scrambled speech on when icon lit.*
* Requires additional hardware option module.
To switch the radio on, press and release the ON/ OFF switch. The radio performs a self-test and a high-pitched start-up tone will be heard.
If the error tone sounds, please contact the person in charge of your radio system or your local Motorola dealer.
To switch the radio off, press and hold the ON/OFF switch for 2 seconds, then release.
Audio Signals/Display Icons /Radio On/Off 3 |
English |
|
|