Miele 292 I, 262 I, 272 I User Manual

0 (0)
Operating instructions
Cooker hoods DA 262 i DA 272 i DA 292 i
In order to protect yourself and avoid damage to your machine, it is absolutely necessary to read the operating instructions prior to installation and operation. M.-Nr. 04 076 101
Description of the appliance
Description of the appliance
1 2 3
DA 262 i
4
DA 272 i / DA 292 i
4 5 6 7 8
2
5 6 7
8
Description of the appliance
The cooker hood is suitable for . . .
. . . Air extraction:
Air is drawn in through the grease
f, cleaned and directed outside.
filter
Description of the appliance
d - Slide switch for ,,Power selec-
tion“
The power of the cooker hood can be adjusted to the intensity of the kitchen vapors and has four settings.
. . . Air recirculation:
Air is drawn in through the grease
f and then through the active
filter charcoal filters for cleaning. It is passed back into the kitchen through the top of the kitchen cabinet.
Before using for the first time, check to see whether the active charcoal filter is in place (see ”Cleaning and Care“).
b - Slide switch for cooktop
illumination n
This is used to switch the cooktop illumi-
on and off, regardless of
g
nation whether the cooker hood is in operation or not. The deflector plate must be pulled out about one inch for the light to work.
0 - Light off l - Light on
The fourth setting (Intensive setting) should be selected for removing very strong kitchen vapors.
low power.......strong power
e - Deflector plate
The deflector plate can be pulled out to any extent up to its limit.
The action of pulling the deflector plate out and pushing it in switches the cooker hood on and off respectively. The slide switch for the fan must be set to setting ,, l “.
h - Grease filter retainer
This is used for securing or releasing the grease filter hood.
f from the cooker
i The control panel can either
c - Slide switch for the fan
This is used to switch the fan on and off. 0 - Fan off
l - Fan on
m
- be fitted with an aluminium front facia panel, available from Miele,
- be fitted with a lightshield from the kitchen furniture programme, or
- be installed without either of the above, but with cover caps (supplied for fitting at each end).
3
Contents
Contents
Description of the appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Help to protect our environment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Warning and Safety instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Cleaning and care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
After Sales Service. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Electrical connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Technical data. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Installation
Appliance dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Wall unit dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16 Building in . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17 Depth alignment. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18 Fitting the light tube cover . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Removing the transit strips. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Fitting the cover caps. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Preparing the lightshield . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 19 Fitting the front facia panel / lightshield . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21 Dismantling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 21
Air extraction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22
Air recirculation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24
4
Help to protect our environment
Help to protect our environment
Disposal of packaging
The transport and protective packing is mostly manufactured from the following re-usable materials:
. . . Corrugated paper / cardboard ­mostly from recycled materials.
. . . CFC-free molded polystyrene. . . . Polyethylene foil (PE) -
partly from secondary raw materials. Rather than just throwing these ma-
terials away, please take them to the nearest local authority collection point for specific waste.
Disposal of your old machine
Old machines contain materials which can be recycled. Please contact your local authorities or scrap merchant about potential recycling schemes, be­fore disposing of the appliance.
Read the notes on page 6 before dis­posing of the appliance.
5
Warning and Safety instructions
Warning and Safety instructions
Read these Operating Instructions carefully before installing or using the Exhaust Hood.
This appliance is intended for residential use only. Use the ap­pliance only for its intended pur­pose. The manufacturer cannot be held responsible for damages caused by improper use of the hood.
Read all the instructions before in­stalling or using for the first time.
SAVE THESE INSTRUCTIONS AND REVIEW THEM PERIODICALLY
This appliance is to be used for
ventilating cooking smoke / odors only. Do not use it to vent hazardous or flammable furnes or materials.
Be certain your appliance is
properly installed and grounded by a qualified technician.
To guarantee the electrical safety
of this appliance, continuity must exist between the appliance and an effective grounding system. It is impera­tive that this basic safety requirement be met. If there is any doubt, have the electrical system of the house checked by a qualified electrician. The manufac­turer cannot be held responsible for damages caused by the lack, or inade­quacy of, an effective grounding sys­tem.
Do not allow children to play with
the hood or its controls.
Repairs on electrical appliances
should only be performed by quali­fied personnel. Do not repair or replace any part of the appliance unless specifi­cally recommended in this manual.
Before servicing, disconnect the
power supply by either removing the fuse or manually “tripping” the cir­cuit breaker.
Do not turn on the hood until it has
been proberly installed.
Do not connect the appliance to
the main electrical supply using an extension cord. Extension cords do not meet the safety requirements of this ap­pliance.
Do not cook on an open flame be-
neath the exhaust hood. Flames could be drawn up into the hood by the suction or the grease filters may ignite.
Do not leave the cooktop unat-
tended while in use. Overheated food can ignite.
When installing the hood, make
sure that the minimum safety distances between the cooktop and hood are maintained.
For electric cooktops: 18" (45 cm) For gas cooktops: 26" (65 cm)
Only metal ductwork should be
connected to the exhaust hood. Any fittings, sealant, or materials used to install the ductwork must be made of non-flammable materials.
6
Warning and Safety instructions
Never connect an exhaust hood to
an active chimney, dryer vent, vent flue, or room ventilating ductwork. Seek professional advice before connecting an exhaust hood vent to an existing, in­active chimney or vent flue.
Do not place this exhaust hood
over cooktops burning solid fuel.
Never operate gas burners without
pots. Heat generated by pro­longed operation of gas burners with­out pots could damage the hood.
Do not use the exhaust hood with-
out the grease filters in place.
Clean the grease filters regularly.
Saturated filters are a fire hazard.
Do not use a steam cleaner to
clean the hood. The steam could penetrate to electrical components and cause a short circuit.
To reduce the risk of cooking fires: – Keep the fan, filters and cooking
area clean and free of grease.
– Turn on the hood when cooking at
high temperatures.
– Heat oils slowly. Only use the high
settings of the range or cooktop when necessary.
– Never leave a turned on range or
cooktop unattended.
– Always use cookware and utensils
that are appropriate for the type and amount of food being prepared.
When connecting the hood to an ex­ternal vent, make sure that there is adequate ventilation in the room where the exhaust hood is to be used.
When using the hood in the same area as other appliances requiring room air (e.g. non-electric water heaters, gas cooktops, gas ovens, etc.) make cer­tain that the air extracted by the hood does not hinder their operation. These appliances need air for combustion.
Adequate ventilation can be main­tained by installing air vents in windows or walls or by ensuring that the hood can only be turned on when the other appliances are off, or vice versa.
To prevent combustion gases being drawn back into the room by the ex­haust hood, the underpressure in the room must be no greater than 6 psi (0,04 mbar) when the hood and these appliances are running simultaneously.
If there are any doubts as to whether there is adequate ventilation, consult an experienced professional.
The above ventilation restrictions and warnings do not apply if the ex­haust hood is retrofitted with an air recirculation kit.
Do not use water on grease fires.
Smother any fire or flame, or use a dry chemical or foam-type extinguisher.
7
Warning and Safety instructions
Warning and safety instructions
Disposal of discarded appliances
Before discarding an old appliance, dis­connect its power cord to prevent it from becoming a hazard.
SAVE THESE INSTRUCTIONS AND REVIEW THEM PERIODICALLY
Throughout the manual, important safety items will be highlighted in boxes and should be read in con­junction with these Warning and Safety instructions”.
8
Operation
Pull out the deflector plate. Drop down the front control panel or
lightshield. Set the slide switch for the fan to po-
sition ”l“. The cooker hood will operate at the
setting the power selector is set to. Select a power setting strong
enough to clear the air:
Operation
After cooking
If, after finishing cooking, there are still cooking vapors in the kitchen, it is rec­ommended that the cooker hood be left on for some minutes longer.
Then switch the cooker hood off by:
moving the slide switch for the fan and the cooktop illumination switch to the ”0“ position.
or
push the deflector plate in.
1 2 3 IS
Setting 1-2 = for normal operation
Setting 3-Intensive setting (IS) = for removing heavy cooking odors
Switch on the cooktop illumination switch if required.
9
Loading...
+ 19 hidden pages