MGE UPS Systems EX15, EX10, EXB10, EX-7, EXB15 User Manual

4 (1)
MGE UPS Systems EX15, EX10, EXB10, EX-7, EXB15 User Manual

PulsarTM

EX7 / EX10 / EX15 EXB10 / EXB15

Manuel d'utilisation

User Manual

Manual de instrucciones

… … … … … …

!

+

% +

%

MGE UPS SYSTEMS

Pulsar EX : 51032233XT/AC

 

 

Thank you for purchasing the EX Uninterruptible Power Supply.

The EX has been designed to provide many years of trouble-free operation. Please review the manual which has been prepared to provide you with all the necessary information concerning the installation and use of your EX.

For service call 1-800-523-0142.

Sincerely,

MGE UPS SYSTEMS

Nous vous remercions pour l’achat de l'Alimentation sans interruption EX. Nous vous invitons à lire ce manuel en souhaitant qu’il apporte tous les éléments nécessaires à l’installation et à l’utilisation de votre onduleur EX.

Appelez le numéro de téléphone 714- 513-7349.

Nous vous prions d’agréer, Madame, Monsieur, nos sentiments les meilleurs.

MGE UPS SYSTEMS

Le agradecemos la compra del ondulador EX.

Lo invitamos a leer este manual esperando que éste le brindará todos los elementos necesarios para la instalación y la utilización de su ondulador EX.

Contáctenos al siguiente número de teléfono 714-513-7349.

Le saludamos a Ud. muy cordialmente.

MGE UPS SYSTEMS

Federal Communications Commission (FCC) Statement

Note: this equipment has been tested and found to comply with Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when equipment is operated in a residential environment. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits.

0

Pulsar EX : 51032233XT/AC

MGE UPS SYSTEMS

note

c this equipment has been tested and found to comply with Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

service and factory repair - call 1 - 800 - 523 - 0142

c direct questions about the operation, repair, or servicing of this equipment to MGE UPS SYSTEMS, Inc. Customer Support Services. Include the part number, assembly number, and serial number of the unit in any correspondence. Should you require factory service for your equipment, contact MGE UPS SYSTEMS, Inc. Customer Support Services and obtain a Return Materials Authorization (RMA) prior to shipping your unit. Never ship equipment to MGE UPS SYSTEMS, Inc. without first obtaining an RMA.

proprietary rights statement

cthe information in this manual is the property of MGE UPS SYSTEMS, Inc., and represents a proprietary article in which MGE UPS SYSTEMS, Inc., retains any and all patent rights, including exclusive rights of use and/or manufacture and/or sale. Possession of this information does not convey any permission to reproduce, print, or manufacture the article or articles shown herein. Such permission may be granted only by specific written authorization, signed by an officer of MGE UPS SYSTEMS, Inc.;

cIBM, PC-AT, ES/9000, and AS/400 are trademarks of International Business Machines Corporation. Other trademarks that may be used herein are owned by their respective companies and are referred to in an editorial fashion only.

two years warranty policy

c MGE UPS SYSTEMS, Inc. (herein after referred to as MGE) warrants Topaz and Pulsar equipment manufactured by MGE to be free from defects in materials and workmanship for a period of two years from date of purchase. If within such period purchaser discovers defective item and promptly notifies MGE in writing, MGE shall repair or replace the item at the Company's option. This warranty shall not apply:

vto equipment not manufactured by MGE,

vto equipment repaired or altered by others than MGE,

vto equipment subjected to negligence, accident, or damage by circumstances beyond MGE's control, or to improper operations, maintenance, or storage, or to other than normal use or service.

With respect to equipment not manufactured by MGE, the Warranty obligations of MGE shall in all respects conform and Warranties do not cover reimbursement for labor, transportation, removal, installation, or other expenses which may be incurred in connection with repairs or replacement. Except as may be expressly provided in an authorized writing by MGE, MGE shall not be subject to any other obligations or liabilities whatsoever with respect to equipment manufactured by MGE or service rendered by MGE. After Sales Service Support Line: 1-800-523-0142.

MGE UPS SYSTEMS

Pulsar EX : 51032233XT/AC

MGE UPS SYSTEMS, Inc.

Postal address:

 

 

1660 Scenic Avenue

 

 

Costa Mesa, CA 92626

 

 

714-557-1636

 

 

 

 

 

51032233XT/AC

Pulsar EX : 51032233XT/AC

MGE UPS SYSTEMS

ENGLISH

IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS

This manual contains important instructions for Models EX7/EX10/EX15/EXB10/EXB15 that should be followed during installation and maintenance of the UPS batteries.

cThis equipment can be operated by any individual, with no previous training;

cCAUTION: Risk of electric shock, even with unit disconnected from AC power source. Hazardous voltage still may be present through operation from battery. The battery supply should be disconnected at the plus and minus terminals using the quick disconnect connectors of the battery when maintenance or service work inside the UPS is necessary.

cThe UPS contains voltages which are potentially hazardous. All repairs should be performed by qualified service personnel only;

cdo not attempt to power the UPS from any receptacle other than a 2-pole 3-wire grounded receptacle;

cdo not place Pulsar near water or in environment of excessive humidity;

cdo not allow liquids or any foreign objects to get inside Pulsar;

cdo not block air vents in the back of

Pulsar;

cdo not plug household appliances such as hair dryers to Pulsar receptacles;

cdo not place Pulsar in direct sunlight or close to heat-emitting source;

cthe AC power receptacle should be near the equipment and easily accessible. To isolate Pulsar from AC input, remove the input power cord from the AC power receptacle;

cif Pulsar is to be stored for a long time, it is recommended to recharge the batteries (by connecting AC power source to Pulsar, switch "ON" or "OFF"), once a month for 24 hours to avoid a full batteries discharge;

cPulsar contains batteries that should be disposed of or recycled in accordance with local applicable laws;

cprior to installation, store Pulsar in a dry location;

cstorage temperatures must be between –4°F (-20°C) and +113°F (+45°C);

cservicing of batteries should be performed or supervised by personnel knowledgeable of batteries and the required precautions. Keep unauthorized personnel away from batteries;

cwhen replacing the batteries, use the same number and the following type of batteries:

v Pulsar EX7: 2 x 12V - 7.2Ah, v Pulsar EX10 : 3 x 12V - 7.2Ah, v Pulsar EX15 : 4 x 12V - 7.2Ah;

c~ : alternating current supply symbol;

cCAUTION: do not dispose of battery or

batteries in a fire. The battery may explode;

cCAUTION: do not open or mutilate the battery or batteries, released electrolyte is harmful to the skin and eyes. It may be toxic;

cCAUTION: a battery can present a risk of electric shock and high short circuit current. The following precautions should be observed when working with batteries:

v remove watches, rings or other metal objects,

v use tools with insulated handles,

v wear rubber gloves, boots and safety glasses;

cplease dispose of the packaging in accordance with the applicable legislation.

MGE UPS SYSTEMS

Pulsar EX : 51032233XT/AC

i

ENGLISH introduction

In critical situations, count on MGE UPS SYSTEMS Pulsar EX7, EX10 and EX15 uninterruptible power supplies (UPS). Their protection keeps your data intact and accessible.

Pulsar EX7, EX10 and EX15 UPSs ensure top quality power around the clock, and continue operations during power failures. An intelligent microprocessor detects any operating anomalies of the UPS and triggers an alarm if corrective action is necessary.

In addition to the high-technology aspect of these UPSs, you can count on backup from our staff, a team of specialists, around the corner from you, throughout the world. It’s no accident that MGE UPS SYSTEMS is the world leader in UPS protection.

application of Pulsar EX7, EX10 and EX15:

Network servers and interconnection devices are very sensitive to electrical disturbances of all types, including outages, voltage sags, brownouts, spikes, etc. The origins of the disturbances also vary, ranging from atmospheric phenomena, to nearby devices generating interference such as elevators, photocopy machines and machine tools, not to mention human errors, like the accidental pulling out of power cords or tripping of circuit breakers. The consequences of these disturbances on computer systems range from data losses to hardware damage (power supplies, hard disks).

Pulsar EX7, EX10 and EX15 are specially designed to protect network servers and all

other interconnection devices that are sensitive to electrical disturbances.

Pulsar EX7, EX10 and EX15 add faulttolerance to the utility supplying your sensitive equipment.

Pulsar EX7, EX10 and EX15 are designed as compact units and feature very silent operation. They can be installed under a desk, and can also be installed in a rack (see "options").

Pulsar EX7, EX10 and EX15 provide a stable supply of clean power, long back-up time during a utility outage (see table) and vast information and control possibilities according to the configuration selected.

Pulsar EX7, EX10 and EX15 On-Line technology provides maximum protection and availability of your workstations, server, and network communication devices.

Pulsar EX7, EX10 and EX15 offer many functions and characteristics designed to simplify power management:

cautomatic battery test carried out periodically. In the event of a fault, a LED provides advance warning for battery replacement;

cfront panel LEDs signal all types of faults and alarms;

cBar graph continuously indicates the battery charge level or the critical load power level;

cPulsar EX7, EX10 and EX15 are environment friendly: all components are recyclable and an electronic power-saver device reduces power consumption if the UPS is not active for a period exceeding 5 minutes while on battery back-up;

cEX Driver software provides rapid startup

of Pulsar EX7, EX10 and EX15 using the EX Tuner configuration module. This module adapts Pulsar EX7, EX10 and EX15 to user preferences (battery test frequency, startup and shutdown sequences, setting of battery thresholds, etc.). Operation and monitoring are ensured by the UPS Manager 3.1 module operating under Windows 3.1.

EX Driver connects to the RS 232 port on the Pulsar EX7, EX10 and EX15 (see "communication" section for further details); c Solution-PacTM is a CD-ROM which contains all the tools needed to supervise your UPS.

iv

Pulsar EX : 51032233XT/AC

MGE UPS SYSTEMS

Loading...
+ 12 hidden pages