Technical InformationDishwasher
MDB8600AWB MDB8600AWQ MDB8600AWS MDB8600AWW MDB9600AWB MDB9600AWQ MDB9600AWS MDB9600AWW
Due to possibility of personal injury or property damage, always contact an authorized technician for servicing or repair of this unit. Refer to Service Manual 16021814.
!CAUTION
All safety information must be followed as provided in Service Manual 16021814.
!WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to dishwasher before servicing, unless testing requires power.
Specifications |
MDB8600AW* |
MDB9600AW* |
Benefits |
MDB8600AW* |
MDB9600AW* |
Power Source |
|
|
Wash cycles |
5 |
6 |
Voltage AC |
120 VAC |
120 VAC |
Heavy Wash |
X |
X |
Amperage |
15 A |
15 A |
Normal Wash |
X |
X |
(Single Unit) |
|
|
|
|
|
Frequency |
60 Hz |
60 Hz |
Light Wash |
X |
X |
Motor |
1/3 |
1/3 |
Rinse Only |
X |
X |
horsepower |
|
|
|
|
|
Receptacle |
N/A |
N/A |
Auto Clean |
X |
X |
Plug |
N/A |
N/A |
Drying System |
X |
X |
Dimensions |
|
|
Features |
|
|
Height−overall |
33 ½” to 35 ¼” |
33 ½” to 35 ¼” |
QuietSeries 300™ |
X |
X |
Width |
23 7/8” |
23 7/8” |
*Sanitizer |
X |
X |
Depth |
23 1/2” |
23 1/2” |
*ToughScrub™ |
X |
X |
Weight |
|
|
*160° Wash |
|
X |
Un-crated |
65 lbs. |
65 lbs. |
*Extra Rinse |
X |
X |
|
|
|
1-9 Hour Delay Start |
X |
X |
|
|
|
Control Lock |
X |
X |
|
|
|
Energy Star |
X |
X |
|
|
|
Active Vent Dry |
X |
X |
|
|
|
Finer Filtration |
X |
X |
|
|
|
Hard Food |
X |
X |
|
|
|
Disposer |
|
|
|
|
|
Remaining Time |
X |
X |
|
|
|
Countdown Display |
|
|
|
|
|
Integrated Control |
|
X |
|
|
|
Panel |
|
|
|
|
|
Angled Panel with |
X |
|
|
|
|
Microprocessor |
|
|
|
|
|
Controls |
|
|
|
|
|
11 Touch Pad |
X |
|
|
|
|
Controls |
|
|
|
|
|
13 Touch Pad |
|
X |
|
|
|
Controls |
|
|
*On selected models only |
|
|
|
|
May 2004 |
1 |
16023220 |
©2004 Maytag Services |
|
|
Component Specifications
!WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to dishwasher before servicing, unless testing requires power.
Illustration |
Component |
Test Procedure |
Results |
|
Dishwasher Motor |
Measure resistance from |
|
|
|
ST5 (Motor Common – blue) to ST8 |
|
|
CCW rotation only |
(Motor Main - yellow) ........................... |
3 to 4 Ω |
|
viewed from shaft |
See Component Specifications/Motor |
|
|
end. |
Connections for details. |
|
1/3HP
120V/60hz, 3.2 amps, 3250 RPM
Main Wattage, 285 watts
Start Wattage, 1115 watts
Control Board See Component Specifications/ Membrane Readings for troubleshooting/pin-out instructions.
Water valve |
Measure resistance from |
|
|
J6 Pin 4 Aqua (Float switch) to ST4 |
|
120V/60hz, 7 watts |
Black (Common) ................................. |
1.1 k Ω |
1.13 ± .10 gpm at 20- |
|
(This value assumes the float switch is |
120 psi |
|
closed). |
Vent wax motor |
Measure resistance from J6 Pin 1 |
120V with 1/4" |
Purple (Vent) to ST4 Black (Common) 1.2 k Ω |
|
|
actuation stroke |
|
within 60 seconds |
|
Dispenser wax motor |
Measure resistance from J6 Pin 3 |
2 k Ω |
|
Tan (Dispenser) to ST4 Black |
|
120V with 1/4" |
(Common). |
|
actuation stroke |
|
|
within 60 seconds |
|
|
16023220 |
2 |
May 2004 |
|
|
©2004 Maytag Services |
Component Specifications
!WARNING
To avoid risk of electrical shock, personal injury, or death, disconnect power to dishwasher before servicing, unless testing requires power.
Illustration |
Component |
Test Procedure |
|
Results |
|
Limit Thermostat |
Close on Temperature drop @ 149°F |
|
|
|
|
± 7°F (Temp) ...................................... |
0 Ω |
= Closed |
|
|
Open on Temperature drop @ 164°F |
|
|
|
|
± 4°F (Temp) ...................................... |
Infinite Ω = Open |
Sensor/Thermistor |
10KΩ ± 3% at 77°F and 2.4 k Ω ± |
|
|
|
6.5% at 140°F |
|
|
|
J5 pin 1 - Orange (Temp) to J5 Pin 4 - |
Infinite Ω = Open |
|
|
Red (Neutral) ..................................... |
||
|
|
0 Ω |
= Closed |
|
|
|
|
Heater/Heating |
Measure resistance from ST1 |
|
|
Element |
Red/Black (Heater) to ST11 White |
|
|
120v/60hz, 650 watts |
(Common) .......................................... |
16 Ω |
|
|
(This value assumes the high limit |
||
± 5% in air, 830 watts |
|
thermostat is closed). |
|
± 5% in coldwater |
|
|
|
|
|
|
|
Drain Motor |
Measure resistance from |
|
|
|
ST6 Gray (Drain) to ST4 Black |
|
|
120v/60hz |
(Common) .......................................... |
25 Ω |
|
|
See section “Motor Connections and |
|
|
|
Diagram” for wiring contacts. |
|
|
May 2004 |
3 |
16023220 |
©2004 Maytag Services |
|
|