Linear DR4-12, DRA-4 User Manual

DR4V		DESCRIPTION The Delta-3 DR4V & DR4-12 digital receivers are			STEP 1 Locate coding switch. Locate the digital coding switch
		four-channel wireless radio controls designed for use with			which is recessed in the center of the back of the receiver case.
		automatic garage/gate operators and access control systems. The			Note that the coding switch has eight keys. The keys are numbered
DR4-12		receivers can be activated by any of the Delta-3 format			1 through 8. Key No. 1 and Key No. 2 are not used for coding the
		transmitters. Receivers must be mounted at least 8 feet apart.			receiver; their functions are permanently wired on the circuit
		The Delta-3 radio format provides 256 different digital codes. The			board.
DIGITAL		codes are set using the 8-position coding switches in the units.			RECEIVER		Brown	N/O
		CAUTION: All transmitters and receivers should be			CODING SWITCH	Ch. 1
							Red	Com.
RECEIVER					WHITE/WHITE
		recoded by the installer prior to operation.					Orange	N/C
					POWER INPUT
		In order to avoid the possibility of duplicating codes in adjacent			DR4V:		Yellow	N/O
		systems, factory set codes should not be used. In addition, among			24 VOLTS AC/DC	Ch. 2
							Green	Com.
Code Setting		the valid codes available, four others should not be used. These			DR4-12:		Blue	N/C
					12 VOLTS AC/DC
Instructions		include: all keys set ON or OFF and keys set alternating ON/OFF.					Violet	N/O
		Activate each transmitter to test the equipment.				Ch. 3
							Grey	Com.
		WARNING! BE SURE DOOR OR GATE					White	N/C
							Black	N/O
		AREAS ARE CLEAR OF OBSTRUCTIONS			12 CONDUCTOR	Ch. 4
							Brown	Com.
					RIBBON. CHANNEL 1
							Red	N/C
[phone] ∙ www.linearcorp.com					STARTS THIS END
STEP 2 Code the receiver. Pick any combination of ON/ OFF		STEP 3 Code the transmitters. Remove the battery access door			STEP 4A Connecting receiver (using transformer power). A
codes and set them on switch keys 3 through 8. Ignore Keys 1 and		located on the back of the transmitter case to set transmitter codes.			Model T12A (used with DR4-12) or 524 (used with DR4-V)
2. The ON position is when the top of the switch is down. The OFF		Transmitter keys 1 and 2 determine which channel the transmitter			transformer can be used to power the receiver when connecting
position is when the top of the switch is up and the bottom is down.		will activate. Keys 3 through 8 must match keys 3 through 8 on			receiver to any operator. Connect as shown, then plug the
The code set on Keys 3 through 8 on the receiver must now be		the receiver. Refer to transmitter code set instructions to code			transformer into a convenient (unswitched) 120 VAC outlet.
matched by all transmitters used in the system.		multi-button transmitters.
		MATCH		MATCH
		3-8		3-8
DR-4 CODING		TRANSMITTER		TRANSMITTER
		#1		#2	RADIO
SWITCH
			1 & 2	1 ON	RECEIVER
					TRANSFORMER
			OFF	2 OFF	DR4V: #524
		TRIGGERS CH. 1			DR4-12: #T12A
				TRIGGERS CH. 2
		MATCH		MATCH			RED	BROWN
		3-8		3-8
		TRANSMITTER		TRANSMITTER	GARAGE DOOR
KEYS 1 & 2		#3		#4	OPERATOR
	SET KEYS 3-8				CONNECT OTHER
				1 & 2
ARE UNUSED	TO ANY CODE		1 OFF		RECEIVER OUTPUTS
					TO ADDITIONAL	MANUAL
			2 ON	ON
		TRIGGERS CH. 3			OPERATORS	PUSHBUTTON
				TRIGGERS CH. 4

STEP 4B Connecting	receiver (using operator power).		STEP 5 Connecting receiver to 3-button commercial operator.							LINEAR LIMITED WARRANTY
Connect the receiver to the garage door or gate operator as shown			Connect normally open outputs to up and down inputs. Connect							This product is warranted to the consumer against defects in material and workmanship for one year from the
										date of purchase. This warranty applies to first retail buyers of new devices. Warrantor will repair, or at its option,
in the diagram. Power will be supplied from the operator.			normally closed	output	in series with the			stop	output. Connect	replace, any device it finds that requires service under this warranty, and will return the repaired or replaced
			receiver power input to operator radio power or transformer.							device to the consumer at the warrantor’s cost. For warranty service and shipping instructions contact warrantor
										at the address shown below. Devices must be sent to warrantor for service at owner’s expense. The remedies
RADIO			WALL STATION						OPERATOR	provided by this warranty are exclusive. Implied warranties under state law are to the one year period of this
										written warranty. Some states do not allow limitations on how long an implied warranty lasts, so the above
RECEIVER									1
			OPEN							limitation may not apply to you. In order to be protected by this warranty, save your proof of purchase and send
				GREEN					2	copy with equipment should repair be required. This warranty gives you specific legal rights, and you may also
										have other rights which vary from state to state.
			CLOSE
					BLUE					All products returned for warranty service require a Return Product Authorization Number (RPA#).
									3
										Contact Linear Technical Services at 1-800-421-1587 for an RPA# and other important details.
			STOP		WHITE					IMPORTANT !!!
RADIO POWER									6
										Linear radio controls provide a reliable communications link and fill an important need in portable wireless
WHITE	RED	BROWN								signaling. However, there are some limitations which must be observed.
					DR-4					For U.S. installations only: The radios are required to comply with FCC Rules and Regulations as Part 15
		NOTE: OPERATOR
										devices. As such, they have limited transmitter power and therefore limited range.
WHITE		MUST SUPPLY			RECEIVER
										A receiver cannot respond to more than one transmitted signal at a time and may be blocked by radio signals
		12 VOLTS AC/DC - DR4-12
										that occur on or near their operating frequencies, regardless of code settings.
		24 VOLTS AC/DC - DR4V		GREEN OPEN		YELLOW
										Changes or modifications to the device may void FCC compliance.
		3 Radio Pwr			CHANNEL 2					Infrequently used radio links should be tested regularly to protect against undetected interference or fault.
				GRAY	CLOSE	VIOLET				A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale distributor or
		2 Relay
					CHANNEL 3					dealer, and these facts should be communicated to the ultimate users.
		1 Common		RED		ORANGE	X	RED		This device complies with FCC Rules Part 15 and IC Canada Rules and Regulations. Operation is subject to
CONNECT OTHER			RED X		STOP					the following two conditions: (1) This device may not cause harmful interference and (2) this device must accept
RECEIVER OUTPUTS TO		OPERATOR			CHANNEL 1					any interference received, including interference that may cause undesired operation.
ADDITIONAL OPERATORS			Splice Red			Splice Orange
	MANUAL					wire to Red
			wire to Red
	PUSHBUTTON				RECEIVER POWER					Copyright © 1999 Linear Corporation	200868 F