Lift-Master 65 6202 User Manual

Size:
220.5 Kb
Download

APPLICATION

Replaces operator hand chain wheel and chain with hook and eyelet connection for extended floor level hand crank. Used on Model H, DH and GH operators. Must be factory installed.

PACKING LIST

INSTRUCTIONS

1.A section of 1/2" rigid electrical conduit must be furnished by the installer. The length of this pipe will vary with each installation and should be determined so as to fix the winding brace handle at chest height when connected to the door operator.

2.Drill a 1/4" diameter hole through each end of the rigid pipe, 1/2" from the end.

3.Attach the eye and winding brace to the ends of the pipe with the screws and nuts provided (Figure 2).

NOTE: If an extended Hand Crank Kit was requested refer to instructions on back page before going onto next step.

4.Connect the hand crank hook shaft in the same manner that the eye is connected to the rigid pipe.

CRANK OPERATION

1.Pull the door operator disconnect chain down and lock in place on the chain retaining bracket (Refer to operator owner’s manual).

2.Slip the eye end of the hand crank over the hook on the extended shaft of the operator and rotate the handle to manually raise or lower the door (Figure 3).

HAND CRANK MODIFICATION

Assembly Instructions

656202 OR 659201

(Models H & DH OR Model GH)

FIGURE 1

Eye

Hook

1/2" Pipe

(Not Provided)

Winding Brace

FIGURE 2

 

FIGURE 3

 

Eye

 

1/4" Nut

 

Hand Crank

1/4" Screw

Hook Shaft

 

1/2" Pipe

Disconnect

 

Chain

 

 

1

(OPTIONAL) HAND CRANK EXTENSION

1.Remove the 5/16" hex bolt and nut from the shaft coupling not holding the extension shaft in place and set of to the the side.

2.Slide the shaft coupling over the hook shaft and secure in place with the hardware previously removed.

3.Refer to step four on front page to complete installation.

FIGURE 4

Hook Shaft

Hex Bolt 5/16-18x 2"

Lock Nut 5/16"

Shaft Coupling

Extension Shaft 30"

Hook (See Step 4)

 

© 2005, The Chamberlain Group, Inc.

 

01-13035B

All Rights Reserved

Printed in Mexico