Lexmark X654DE, X658DTFE, 16M1842, X656DTE, 16M1847 User Manual

...
0 (0)
Lexmark X654DE, X658DTFE, 16M1842, X656DTE, 16M1847 User Manual

Lexmark™ X65x

Quick Reference

Loading paper and specialty media

Loading the standard or optional 250-sheet or 550-sheet tray

Although the 250-sheet tray and the 550-sheet tray are different in appearance, they require the same process for loading paper. Use these instructions to load paper in either tray:

1 Pull the tray out.

Note: Do not remove trays while a job prints or while Busy appears on the display. Doing so may cause a jam.

2 Squeeze the width guide tab inward as shown, and move the width guide to the correct position for the paper size being loaded.

3Unlock the length guide, squeeze the length guide tab inward as shown, and slide the guide to the correct position for the paper size being loaded.

Notes:

Use the size indicators on the bottom of the tray to help position the guides.

For standard paper sizes, lock the length guide.

4Flex the sheets back and forth to loosen them, and then fan them. Do not fold or crease the paper. Straighten the edges on a level surface.

1

5Load the paper stack:

Print side facedown for single-sided printing

Print side faceup for duplex printing

Note: Paper must be loaded differently in the trays if an optional StapleSmartTM II Finisher is installed. For more information, see the User's Guide.

Note: Notice the maximum fill line on the side of the tray which indicates the maximum height for loading paper. Do not overload the tray.

6If necessary, adjust the paper guides to lightly touch the sides of the stack, and lock the length guide for the paper sizes indicated on the tray.

7 Insert the tray.

3 Unlock the length guide.

8If a different type of paper was loaded than the type previously loaded in the tray, then change the Paper Type setting for the tray from the printer control panel.

Loading the 2000-sheet tray

1Pull the tray out.

2Pull up and slide the width guide to the correct position for the paper size being loaded.

2

4Push the length guide release latch to raise the length guide, slide the guide to the correct position for the paper size being loaded, and then lock the guide.

5Flex the sheets back and forth to loosen them, and then fan them. Do not fold or crease the paper. Straighten the edges on a level surface.

6Load the paper stack:

Print side facedown for single-sided printing

Print side faceup for duplex printing

Note: Paper must be loaded differently in the trays if an optional StapleSmart II Finisher is installed. For more information, see the User's Guide.

Note: Notice the maximum fill line on the side of the tray which indicates the maximum height for loading paper. Do not overload the tray.

7 Insert the tray.

Loading the multipurpose feeder

1 Pull down the multipurpose feeder door.

2 Pull out the extension until it is fully extended.

3

Loading...
+ 5 hidden pages