Front Roller Kit
Assembly Instructions
|
FDR2560, FDR2572 & FDR2584 Models |
Manual No. 310-324M |
|||
|
|
|
|
|
|
|
Before You Start |
Assembly Instructions |
|||
|
|
|
|
|
|
|
|
|
|
|
|
When you see this symbol, the subsequent
!instructions and warnings are serious - follow without exception. Your life and the lives of others depend on it!
IMPORTANT: Before you begin, read these instructions and check to be sure all parts and tools are accounted for. Please retain these installation instructions for future reference and parts ordering information.
Your Front Roller Kit is exclusively designed for your Land Pride groming mower. Please read these installation instructions and your groming mower Operator’s Manual thoroughly before beginning. Especially read information relating to safety concerns. Also included in the Operator’s Manual is important information on operation, adjustment, troubleshooting, and maintenance for this attachment (some manual sections do not apply to all accessories).
A separate Parts Manual for replacement parts can be purchased from your dealer or available free of charge at www.landpride.com. Have model and serial numbers handy when placing an order.
Manual Part Numbers:
•Operator’s Manual . . . . . . . . . . . . . . . . . 310-262M
•Parts Manual . . . . . . . . . . . . . . . . . . . . . 310-069P
General Information
These assembly instructions apply to the Front Roller option listed below:
310-254S FRONT ROLLER ASSEMBLY
Tools required:
•Safety Glasses
•Work Gloves
•Two 3/4" wrenches
•Two 9/16" wrenches
A detailed listing of parts for each accessory kit is provided on page 2. Use the list that is for your groming mower as a checklist to inventory parts received. Please contact your local Land Pride dealer for any missing hardware.
Front Roller Assembly
Refer to Figure 1:
1.Remove the front two 1/2”-13 x 1 1/2” GR5 hex flange serrated screws (#9) and reinsert from the bottom as shown. Secure with existing 1/2” whiz nuts (#10).
Tighten nuts to 76 ft-lbs of torque.
2.Assemble brackets (#2) and (#3) to deck with carriage bolts (#4) and flange nuts (#5).
3.Insert roller (#8) between brackets and install pin (#1) through brackets and roller. Secure with washer (#6) and cotter pin (#7).
17713
FDr2560, FDR2572 & FDR2572 Front Roller Assembly
Figure 1
© Copyright 2005 |
Pr inted |
9/29/06 |
1 |