BOOK# 091-9-3
INSTRUCTION MANUAL
®
AUTO-PUMP
12VDC
AIR COMPRESSOR SYSTEM
MODEL #091-9
NOTE :
The 091-9 Auto-Pump consists of a 12volt motor driven compressor
INPUT :12 volt, 12 amp
OUTPUT :100 PSI MAXIMUM
1 YEAR WARRANTY
KUSSMAUL ELECTRONICS CO., INC.
170 CHERRY AVE., WEST SAYVILLE, N.Y. 11796
TEL: in NY 631-567-0314 |
TOLL FREE: 800-346-0857 |
FAX: 631-567-5826 |
INTRODUCTION
The Auto-Pump Air Compressor system is a compact electric motor operated single cylinder air compressor designed specifically for installation on vehicles with air brakes . During long idle periods of the vehicle when even the slightest seepage can cause an air brake system pressure to drop below the brake lockup pressure, the Auto Pump automatically starts to maintain the pressure.
The Auto Pump motor is directly coupled to the compressor section eliminating all belts and pulleys assuring long life and reliable operation . A heavy duty pressure switch is adjusted to start the compressor when the system pressure drops below 75 psi and stops the compressor when 95 psi is attained . The start up pressure is field adjustable - the pressure differential between start up and stopping is fixed. Please read and follow the installation instructions carefully . The Auto Pump requires no routine maintenance . A careful installation will assure years of trouble free operation.
CAUTION
NO CONDENSATE OR WATER MUST BE ALLOWED TO ENTER OR ACCUMULATE INTHE OUTPUT
OF THE AUTO PUMP.
ROUTE OUTPUT PRESSURE LINE DOWNWARD FROM AUTO PUMP TO PERMIT MOISTURE TO DRAIN AWAY.
WATER IN THE PUMP OUTLET WILL INDUCE
FAILURE !
WATER DAMAGE WILL
VOID WARRANTY
Loading...