Keurig® Brewer De-Scaling Instructions
Brewer Model: MINI Plus B31
To begin, you will need the following:
•20 oz. of undiluted white vinegar
•12 oz. ceramic mug (do not use a paper cup)
•Access to an empty sink
FILL, CLEAN AND RINSE
Step 1: First Vinegar Rinse
•Fill the Cold Water Reservoir with 10 oz. of undiluted white vinegar.
•Place the ceramic mug on the Drip Tray.
•Lift the Brewer Handle, but DO NOT ADD A K-CUP.
•After 5 seconds, lower the Brewer Handle.
•Press the flashing blue BREW Button. It will flash red and then turn solid red.
•Once the vinegar is dispensed, discard hot contents into sink.
Step 2: Second Vinegar Rinse
•Pour the remaining 10 oz. of vinegar into the Cold Water Reservoir.
•Place the ceramic mug on the Drip Tray.
•Lift the Brewer Handle, but DO NOT ADD A K-CUP.
•After 5 seconds, lower the Brewer Handle.
•Press the flashing blue BREW Button. It will then flash red.
•When it turns solid red, power off as it starts to dispense.
•Allow Brewer to sit for 30 minutes.
•Power on the Brewer, lift and lower Brewer Handle, then press BREW Button.
•Once the vinegar is dispensed, discard hot contents into sink.
Step 3: Fresh Water Rinse
•Fill the Cold Water Reservoir with 10 oz. of fresh water.
•Place the ceramic mug on the Drip Tray.
•Lift the Brewer Handle, but DO NOT ADD A K-CUP.
•Lower Brewer Handle and continue the brewing process until the hot water is dispensed into the mug. Discard hot contents into sink.
•Repeat this cleansing brew process three (3) more times to cleanse the Brewer plumbing and to remove any residual vinegar taste. The Brewer is now ready for normal use again.
Brewer Model: Elite B40 | Classic B44 Special Edition B60 | Platinum B70
To begin, you will need the following:
•48 ounces of undiluted white vinegar
•Large ceramic mug (do not use a paper cup)
•Access to an empty sink
PREPARE
Step 1: Empty the water in the Water Reservoir. Step 2: Disable “Auto Off” features.
FILL AND CLEAN
Step 1: Pour approximately 48 ounces of the vinegar into the Water Reservoir.
Step 2: Place a large mug on the Drip Tray Plate and run a brew cycle. DO NOT USE A K-CUP, just press the BREW Button. Pour the contents of the large mug into the sink.
Step 3: Repeat the brew process without a K-Cup until “ADD WATER” is indicated.
Step 4: Now let the Brewer stand for at least 4 hours while still on.
Step 5: Discard any residual vinegar and rinse the Water Reservoir thoroughly.
RINSE
Step 1: Ensure the Water Reservoir is filled with fresh water.
Step 2: Place a large mug on the Drip Tray Plate and water brew cycle. Pour the contents of the large mug into the sink.
Step 3: Repeat brew process until “ADD WATER” is indicated.
Step 4: You may need to perform additional water brew cycles if you notice any residual taste.
NOTE: If “DE-SCALE” is still displayed after completing the procedure, repeat the de-scaling procedure above.
© 2011 Keurig, Incorporated All Rights Reserved.
Loading...