FP510 series
FP520 series
FP530 series
1
safety
● The blades and discs are very sharp, handle with care. |
a |
Always hold the knife blade by the finger gripa at the top, away from the cutting edge, both when handling and cleaning.
●Always remove the knife blade before pouring contents from the bowl.
●Keep hands and utensils out of the processor bowl and liquidiser jug whilst connected to the power supply.
●Switch off and unplug:
●before fitting or removing parts
●after use
●before cleaning
●Never use your fingers to push food down the feed tube. Always use the pusher/s supplied.
●Before removing the lid from the bowl or liquidiser/mill from the power unit:-
●switch off;
●wait until the attachment/blades have completely stopped;
●Be careful not to unscrew the liquidiser jug or mill from the blade unit.
●Allow hot liquids to cool before blending in the liquidiser - if you haven’t fitted the lid securely and it comes off, you could get splashed.
●This machine will be damaged and may cause injury if the interlock mechanism is subjected to excessive force.
●Do not use the lid to operate the processor, always use the on/off speed control.
●This machine is not intended for use by young children or infirm persons without supervision.
●Never use an unauthorised attachment.
●Don’t let children play with this machine.
●Never leave the machine on unattended.
●Never use a damaged machine. Get it checked or repaired: see ‘service’.
●Never let the power unit, cord or plug get wet.
●Don’t let excess cord hang over the edge of a table or worktop or touch hot surfaces.
●Never misuse your food processor and only use it for its intended domestic use. before plugging in
●Make sure your electricity supply is the same as the one shown on the underside of your machine.
importantUK only
●The wires in the cord are coloured as follows: Blue = Neutral
Brown = Live
●This appliance complies with European Economic Community Directive 89/336/EEC.
before using for the first time
1Remove all packaging including the plastic blade covers from the knife blade.
Take care the blades are very sharp. These covers should be discarded as they are to protect the blade during manufacture and transit only.
2Wash the parts see ‘cleaning’
key
processor
pushersfeed tubelid
detachable drive shaftbowl
safety interlock
cord storage (at back)power unit
speed/pulse control
liquidiser outlet/interlock
liquidiser outlet cover/safety interlock
liquidiser
blade unit sealing ring
juglid
filler cap
additional attachments
Not all of these attachments listed below will be included with your food processor. Please refer to your content list supplied. To buy an attachment not included in your pack, contact the dealer from whom you purchased your appliance.
knife blade
dough tool (FP530 only)twin beater geared whiskmaxi-blend canopy
21 thick slicing/coarse shredding disc
22 thin slicing/fine shredding disc (FP520/FP530)23 fine (Julienne style) chipper disc (FP530 only)24 rasping disc (UK pack - not supplied)
25 geared citrus press (FP520/FP530)26 mill (if supplied)
27 KENSTORE™ attachments carousel28 spatula
29 recipe book (if supplied)
to use your food processor
●When using the food processor bowl, the liquidiser outlet cover must be fitted and locked in position or the processor will not work. Ensure the ▼ on the outlet cover lines up with the ▲ on the power unit.
1Fit the bowl. Place the handle towards the back, lower and turn clockwise until it locks .
2Then fit the detachable shaft over the power unit fixed shaft.
3Fit an attachment over the drive shaft.
●Always fit the bowl and attachment onto the machine before adding ingredients.
4Fit the lid onto the bowl - turn clockwise until the arrow on the lid aligns with the line on the outlet cover.
5Switch on and select a speed.
●The processor won’t work if the lid or outlet cover are fitted incorrectly.
●Use the pulse (P) for short bursts. The pulse will operate for as long as the lever is held in position.
6Reverse the above procedure to remove the lid, attachments and bowl.
●Always switch off before removing the lid. important
●Your processor is not suitable for crushing or grinding coffee beans, or converting granulated sugar to caster sugar.
●When adding almond essence or flavouring to mixtures avoid contact with the plastic as this may result in permanent marking.
to use your liquidiser
1 Fit the sealing ring into the blade unit - ensuring the seal is located correctly.
Leaking will occur if the seal is damaged or not fitted correctly.
2Screw the jug onto the blade unit.
3Put your ingredients into the jug.
4Put the filler cap in the lid, then turn.
5Turn the lid in a clockwise direction to lock onto the jug.
6Remove the liquidiser outlet cover by turning in an anti-clockwise direction.
7Place the liquidiser onto the liquidiser outlet and turn to lock .
2
Loading...