Kenwood CM551 User Manual

5 (1)
Kenwood CM551 User Manual

12 10 8 6 4 2

ON

OFF

Auto

OFF

 

 

ON

 

 

 

Prog

 

 

 

H

 

 

 

M

 

CM450 CM550 series series

safety

Never operate the coffee dispensing lever by hand, always use a cup or mug.

Watch out for steam, never lift the lid or remove parts during the brewing cycle.

Take care when dispensing coffee, as burns can occur from touching hot liquids.

Never touch the keep warm plate during or after the brewing cycle.

Always use the handles provided to remove parts from the BrewMaster.

Keep children away from the

machine. And never let the cord hang down where a child could

grab it.

Never use a damaged machine. Get it checked or repaired: see ‘service’.

Never put the machine in water or let the cord or plug get wet - you could get an electric shock.

Unplug:

before filling with water

before cleaning

after use.

Never leave the machine on unattended.

Don’t let the cord touch hot parts.

Don’t let infirm people use the machine without supervision.

Don’t let children play with this machine.

Only use the machine for its intended domestic use.

Always make sure there is water in the water reservoir before switching on.

before plugging in

Make sure your electricity supply is the same as the one shown on the

underside of your machine.

important (UK) only

The wires in the cord are coloured as follows:

Green and Yellow = Earth Blue = Neutral

Brown = Live.

The appliance must be protected by a 13A approved (BS1362) fuse.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Note:

For non-rewireable plugs the fuse cover MUST be refitted when replacing the fuse. If the fuse cover is lost then the plug must not be used until a replacement can be obtained. The correct fuse cover is identified by colour and a replacement may be obtained from your Kenwood Authorised Repairer (see Service).

If a non-rewireable plug is cut off it must be DESTROYED IMMEDIATELY. An electric shock hazard may arise if an unwanted non-rewireable pug is inadvertently inserted into a 13A socket outlet.

This machine complies with European Economic Community Directive 89/336/EEC.

before using for the first

time

1Remove all packaging

2Wash the parts: see ‘care and cleaning’.

3Run two lots of water through the machine (without coffee) to clean it out. Each time pour one coffee tank of cold water filled to the “MAX” level into the water reservoir. See ‘to make coffee’.

key

permanent filterfilter holder

coffee tank

hot coffee outletlid

water reservoirkeep warm plate

coffee dispensing lever measuring scoop

drip tray

ON/OFF button (CM450 series only)

CM550 series only

clock

Auto/ON/OFF button

Prog (programme) buttonhour button

minute button

to make coffee

1Fill the coffee tank with the desired amount of water. Use the markings on the inside below the pouring spout as a guide. Do not exceed the “MAX” level.

Use cold water. We recommend using filtered water from a Kenwood Water Filter as it reduces limescale. Never use warm or fizzy

water.

2Pour the water from the coffee tank into the water reservoir.

3Place the coffee tank on the keep warm plate, then fit the filter holder.

4Place the permanent filter into the filter holder.

5For each cup of coffee required, place one level spoon of filter coffee into the permanent filter. Adjust quantity to taste.

6Close the lid.

7Plug into the power supply.

CM450 series

Press the “ON/OFF” button, the light will come on and brewing will commence.

CM550 series

Press the “Auto/ON/OFF” button twice for coffee to be produced straight away, the light will come

on and brewing will commence. If you want to use the automatic brew facility follow the instructions to set the clock and to programme automatic brew.

8To dispense coffee, press the coffee dispensing lever with a cup and coffee will flow out. Never press the dispensing lever with your hand. To stop the flow remove the cup. Coffee may be dispensed during and after brewing.

To preserve heat and flavour, DO NOT open the lid during or just after brewing.

9The BrewMaster will keep the coffee warm and then automatically switch off after 2 hours. To manually switch off earlier, press the “ON/OFF” button.

to make tea

Follow the procedure for making coffee using tea leaves instead of filter coffee.

Place the desired amount of loose tea into the permanent filter using the spoon provided. The amount will vary depending upon the type of tea used and individual tastes but as a guide use 4 - 6 spoons of loose tea per maximum capacity of water. Some experimentation will be necessary to obtain the desired result.

For best results we recommend that only the required amount of tea is made at one time and that the tea is drunk within half an hour of brewing.

Loading...
+ 1 hidden pages