HO97916
USB 2.0 7-Port Hub
INSTRUCTION
MANUAL
www.jascoproducts.com
Table of Contents
I. |
INTRODUCTION |
3 |
II. |
OVERVIEW |
4 |
III. |
SAFETY INSTRUCTIONS |
5 |
IV. |
POWER MODE SETTING |
6 |
V. |
HUB STAND ASSEMBLY |
7 |
|
|
|
VI. HARDWARE INSTALLATION |
13 |
|
|
|
|
VII. SOFTWARE INSTALLATION |
15 |
|
VIII. TROUBLESHOOTING |
16 |
|
IX. TECHNICAL SPECIFICATIONS |
17 |
|
X. |
FCC COMPLIANCE STATEMENT |
18 |
XI. |
WARRANTY |
19 |
I.Introduction
Please read this entire manual carefully before using your new USB 2.0 7-Port Hub and follow the instructions to prevent damage to the USB 2.0 7-Port Hub and/or the connecting devices.
THIS PACKAGE INCLUDES:
•USB 2.0 7-Port Hub
•USB 2.0 Device Cable (6 feet)
•AC/DC Power Adapter
•User’s Manual
•Two Magnets
•Two metal magnet holders
•Two ¼” screws
3
II.Overview
This USB 2.0 7-Port Hub allows you to connect up to seven USB devices to a single USB port on your computer, including up to five high-powered devices, simultaneously. This device complies with USB 2.0 specifications and supports data speeds up to 480 Mbps. It is compatible with all USB 1.1 and 2.0 devices. You can stack multiple hubs together to support up to 127 devices through a single USB port on your computer.
FEATURES
•USB 1.1 and 2.0 compatible
•Stackable and Mountable via magnets or screws
•Connect up to 5 high powered devices at once
•1 LED to indicate power
•7 LEDS to indicate individual port activity
•Plug and Play
•Bus fault detection and recovery
•Per port over-current detection and protection
•Self-power mode used
4
III.Safety Instructions
Always read the Safety Instructions carefully.
Keep this user’s manual for future reference.
Keep this equipment away from humidity.
Lay this equipment on a reliable flat surface before setting it up.
If any of the following situations arises, get the equipment checked by a service technician:
•The equipment has been exposed to moisture.
•The equipment has been dropped and damaged.
•The equipment has obvious sign of breakage.
•The equipment is not working well.
•If you cannot get it to work according to this User’s Manual refer to the Warranty in Section XI.
5
IV. Power Mode Setting
There are two power mode options for the USB 2.0 7-Port Hub.
The first is self-power mode (recommended), which requires the use of the AC power adapter. In this mode, a maximum of five (5) high-powered USB devices may be connected to the hub at one time. If more than five high-powered devices are connected, you will notice a decrease in performance. (An additional hub is considered a high-powered device.)
The second is bus-power mode, which does NOT require the use of the AC power adapter. In this mode, the hub is provided with 500 milliamps for all 7 ports. This should be adequate for mice, keyboards, and other low power devices. If you are not sure or if device performance is poor, use the AC adapter.
When using the AC power adapter, make sure the plug is properly connected to a standard electrical outlet. Surge protection is recommended.
6