Impex MP-3105 User Manual

	NOTE:
	Please read all instructions
	carefully before using this
	product
		MARCY PLATINUM
	Table of Contents	SMITH CAGE
	Safety Notice
		MP-3105
	Hardware Identifier
	Assembly Instruction
	Parts List
	Warranty
	Ordering Parts
	Model
	MP-3105
	Retain This
	Manual for
	Reference
	12-27-06
	OWNER'S
	MANUAL
		IMPEX®
		14777 DON JULIAN RD., CITY OF INDUSTRY, CA 91746
		Tel: [phone] Fax: [phone]
		www.impex-fitness.com
		[e-mail]

TABLE OF CONTENTS
BEFORE YOU BEGIN......................................................................................	1
IMPORTANT SAFETY NOTICES.....................................................................	2
HARDWARE PACK….......…..........................................……………………….	4
ASSEMBLY INSTRUCTIONS...........................................…………………….	8
EXPLODED DIAGRAM……………………………………………………………..	23
PARTS LIST………..………………………………………………………………..	25
WARRANTY.................................................................................................….	26
ORDERING PARTS.......................................................................................…	26

BEFORE YOU BEGIN

Thank you for selecting the MARCY PLATINUM Smith Cage MP-3105 by IMPEX®. For your safety and benefit, read this manual carefully before using the machine. As a manufacturer, we are committed to provide you complete customer satisfaction. If you have any questions, or find there are missing or damaged parts, we guarantee you complete satisfaction through direct assistance from our factory. To avoid unnecessary delays, please call our TOLL-FREE customer service number. Our Customer Service Agents will provide immediate assistance to you.

Toll-Free Customer Service Number 1-800-999-8899

Mon. - Fri. 9 a.m. - 5 p.m. PST www.impex-fitness.com [e-mail]

1

IMPORTANT SAFETY NOTICE

PRECAUTIONS

This exercise machine is built for optimum safety. However, certain precautions apply whenever you operate a piece of exercise equipment. Be sure to read the entire manual before you assemble or operate your machine. In particular, note the following safety precautions:

1.Keep children and pets away from the machine at all times. DO NOT leave children unattended in the same room with the machine.

2.Only one person at a time should use the machine.

3.If the user experiences dizziness, nausea, chest pain, or any other abnormal symptoms, STOP the workout at once. CONSULT A PHYSICIAN IMMEDIATELY.

4.Position the machine on a clear, leveled surface. DO NOT use the machine near water or outdoors.

5.Keep hands away from all moving parts.

6.Always wear appropriate workout clothing when exercising. DO NOT wear robes or other clothing that could become caught in the machine. Running or aerobic shoes are also required when using the machine.

7.Use the machine only for its intended use as described in this manual. DO NOT use attachments not recommended by the manufacturer.

8.Do not place any sharp object around the machine.

9.Disabled person should not use the machine without a qualified person or physician in attendance.

10.Before using the machine to exercise, always do stretching exercises to properly warm up.

11.Never operate the machine if the machine is not functioning properly.

12.A spotter is recommended during exercise.

CARE AND MAINTENANCE

1.Lubricate moving parts with WD-40 or light oil periodically.

2.Inspect and tighten all parts before using the machine.

3.The machine can be cleaned using a damp cloth and mild non-abrasive detergent. DO NOT use solvents.

4.Maximum user’s weight: 300 lbs.

5.Maximum weight on Rack: 600 lbs.

6.Maximum weight on Smith Bar: 300 lbs.

7.Maximum weight on Weight Holder: 200 lbs.

8.Maximum weight on Leg Developer: 100 lbs.

WARNING: BEFORE BEGINNING ANY EXERCISE PROGRAM, CONSULT YOUR PHYSICIAN. THIS IS ESPECIALLY IMPORTANT FOR INDIVIDUALS OVER THE AGE OF 35 OR PERSONS WITH PRE-EXISTING HEALTH PROBLEMS. READ ALL INSTRUCTIONS BEFORE USING ANY FITNESS EQUIPMENT. IMPEX ASSUMES NO RESPONSIBILITY FOR PERSONAL INJURY OR PROPERTY DAMAGE SUSTAINED BY OR THROUGH THE USE OF THIS PRODUCT.

SAVE THESE INSTRUCTIONS.

2

WARNING LABEL REPLACEMENT

The warning labels shown here have been placed on the Cross Brace, Rear Stabilizer, and Upper Frame. If the labels are missing or illegible, please call customer service at 1-800-888-8899 for replacements. Apply the labels in location shown.

3

HARDEWARE PACK

4

HARDEWARE PACK

5

HARDEWARE PACK

6

HARDEWARE PACK

7

ASSEMBLY INSTRUCTION

Tools Required Assembling the Machine: Two Adjustable Wrenches and Allen Wrenches.

NOTE: It is strongly recommended two or more people assembling this machine to avoid possible injury.

STEP 1 (See Diagram 1)

A.) NOTE: Do not tighten the Nuts and Bolts until instructed to do so.

B.) Attach one Diagonal Support (#3) to the Right Cross Brace (#15). Secure it with one 3 ¾” x 2 3/8” Bent Bracket (#26), M10 x 2 3/8” Carriage Bolt (#81), Ø ¾” Washer (#87), and M10 Aircraft Nut (#89) to the front hole. Secure the back hole with one M10 x 2

1/8” Allen Bolt (#74) and Ø ¾” Washer (#87). Repeat the same procedure to install the other Diagonal Support to the Left Cross Brace (#14).

C.) Attach the Left & Right Cross Brace (#14 & #15) to the Rear Vertical Beam (#10). Secure them together with two M10 x 2 ¾” Carriage Bolts (#83), Ø ¾” Washers (#87), and M10 Aircraft Nuts (#89).

D.) Attach the Foot Plate (#34) to the front of Rear Vertical Beam (#10). Attach the Weight

Glide Post Base (#11) to the back of Rear Vertical Beam. Align the holes and secure them together with two M10 x 2 3/8” Allen Bolts (#75), four Ø ¾” Washers (#87), and two M10 Aircraft Nuts (#89).

E.) Secure the Foot Plate (#34) to the Rear Vertical Beam (#10) with one M10 x 3” Allen

Bolt (#77), two Ø ¾” Washers (#87), and one M10 Aircraft Nut (#89).

8