Hunter Fan 30057, 30067, 30124, 30251 User Manual

0 (0)
1
© 2003 Hunter Fan Company 41663-01 9/19/2003
2
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THIS AIR
PURIFIER AND SAVE THESE IMPORTANT INSTRUC-
TIONS
1. This Air Purifier is designed for use on a flat, level surface and may not work properly on an uneven surface. ALWAYS place this Air Purifier on a firm, level surface. ALWAYS place the Air Purifier at least six (6) inches away from walls and heat sources such as stoves, radiators, or heaters.
2. Place the Air Purifier in an area that is out of the reach of children.
3. Before using the Air Purifier, extend the cord and inspect for any signs of damage. DO NOT use the product if the cord has been damaged.
4. This product has a polarized plug (one blade is wider than the other) as a safety feature. This plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat or override this safety feature.
5. ALWAYS UNPLUG the Air Purifier when it is not in operation, while the filter is being changed, and while it is being cleaned.
6. DO NOT tilt or move the Air Purifier while it is in operation. Shut off and unplug before moving.
7. DO NOT immerse the Air Purifier in water as permanent damage will occur. Refer to and follow the CLEANING AND FILTER REPLACE­MENT instructions.
Introduction
Thank you for purchasing the HEPAtech™ Air Purification System from Hunter Fan Company. You have purchased our latest development in portable Air Purifi­cation Systems. This system has been developed to improve the quality of the air you breathe.
Our HEPAtech™ Air Purification System out performs other air purification sys­tems by quickly and effectively removing dust, smoke, and pollen particles as small as .1 microns in size. Room air is pulled in through the front grill and cleaned across the HEPAtech™ filter. Clean air is then released out the top grill in order to avoid stirring up settled particles.
41663-01 9/19/2003 © 2003 Hunter Fan Company
Using the Ionizer
Using the ionizer improves the quality of air in the room. Negative ions are re­leased into the air and positively charged dust, smoke, and pollen particles are attracted to the negative ions. These particles settle out of the air and can be vacu­umed up during normal cleaning. These particles are also more easily captured by the HEPAtech™ filter as they pass through the HEPAtech™ Air Purification Sys­tem. To ensure the best air circulation in the room, we recommend that you place your air purifier six inches away from any walls.
Using Your Air Purifier
1. Remove your air purifier from the box and take it out of the clear plastic pro­tective bag.
2. Place your HEPAtech™ Air Purification System on a firm, flat surface.
3. Before turning the Air Purifier ‘on’, you need to open the front grill.
For Models 30057 & 30251:
To release the front grill, place your fingers behind the tabs and pull forward.
For Models 30067 & 30124:
To release the front grill, press the buttons on the side until the front grill slides easily over the buttons.
4. The filter will be installed in the correct position. Grasp the filter and pull it forward. Remove the plastic wrapping and replace the filter in the unit. The white filter material should be facing outward (towards you) and the wire mesh side should be hidden from view (inside the unit).
5. Replace the front grill. Be sure that the bottom tabs are in location first, and then push the top of the grill forward until it is closed. The unit is now ready for normal operation. Note: This unit will not operate unless the door is placed in the correct position.
6. Plug the unit into a 120V electrical outlet.
3
© 2003 Hunter Fan Company 41663-01 9/19/2003
Loading...
+ 5 hidden pages