Hunter Fan 30377 User Manual

0 (0)
Hunter Fan 30377 User Manual

HEPAtech

Air Purification System

HEPAtech™ 377 (Model 30377)

Remote Control Included

This air purifier uses Model 30930 replacement filters.

WWW.HUNTERFAN.COM

FORM 41505-01 Rev 6-12-2001

© 2001 HUNTER FAN CO.

IMPORTANT SAFETY INSTRUCTIONS

READ ALL INSTRUCTIONS BEFORE USING THIS AIR PURIFIER AND SAVE THESE IMPORTANT INSTRUCTIONS

1.This Air Purifier is designed for use on a flat, level surface and may not work properly on an uneven surface. ALWAYS place this Air Purifier on a firm, level surface. ALWAYS place the Air Purifier at least six (6) inches away from walls and heat sources such as stoves, radiators, or heaters.

2.Place the Air Purifier in an area that is out of the reach of children.

3.Before using the Air Purifier, extend the cord and inspect for any signs of damage. DO NOT use the product if the cord has been damaged.

4.This product has a polarized plug (one blade is wider than the other) as a safety feature. This plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat or override this safety feature.

5.ALWAYS UNPLUG the Air Purifier when it is not in operation, while the filter is being changed, and while it is being cleaned.

6.DO NOT tilt or move the Air Purifier while it is in operation. Shut off and unplug before moving.

7.DO NOT immerse the Air Purifier in water as permanent damage will occur. Refer to and follow the CLEANING AND FILTER REPLACEMENT instructions.

Introduction

Thank you for purchasing the HEPAtech™ Air Purification System from Hunter Fan Company. You have purchased our latest development in portable Air Purification Systems. This system has been developed to improve the quality of the air you breathe.

Our HEPAtech™ Air Purification System out performs other air purification systems by quickly and effectively removing dust, smoke, and pollen particles as small as .1 microns in size. Room air is pulled in through the front grill and cleaned across the HEPAtech™ filter. Clean air is then released out the top grill in order to avoid stirring up settled particles.

Using the Ionizer

Using the ionizer improves the quality of air in the room. Negative ions are released into the air and positively charged dust, smoke, and pollen particles are attracted to the negative ions. These particles settle out of the air and can be vacuumed up during normal cleaning. These particles are also more easily captured by the HEPAtech™ filter as they pass through the HEPAtech™ Air Purification System. To ensure the best air circulation in the room, we recommend that you place your air purifier six inches away from any walls.

FORM 41505-01 Rev 6-12-2001

2

© 2001 HUNTER FAN CO.

Air Purifier Features

Electronic Key Pad Control

1.On/Speed Control: Press this button to turn the unit ‘on’. When you press it once, the unit will be on low speed. Keep pressing the button to change speeds until you reach the speed you desire.

2.Automatic Shut-off: If you desire the air purifier to shut off automatically, you can set the timer. Press the timer button to choose the amount of time you would like the air purifier to run (1, 2, 4, or 8 hours). Press the button repeatedly to change the length of time.

3.Ionizer: Press this button to turn ‘on’ the ionizer. When the ionizer is ‘on’, the green light to the left of the button will be illuminated.

4.Check Filter: When the check filter light is illuminated, you should open the front grill and compare the filter to the check filter chart. If the filter is dark, you should replace the filter.

5.Reset: When you change the filter, press the reset button. Use the tip of a pen or pencil to press the reset button.

AIR PURIFIER PARTS

RECESS FOR

 

FINGERS TO

HEPAtech™ 377

PULL OPEN

FRONT GRILL

FIGURE 1

FRONT

 

GRILL

 

Remote Control

 

1. Controls: For your convenience, a remote control is pro-

 

vided with this air purifier. The remote may be used to turn

 

the air purifier on or off, adjust the fan speed, set the timer,

 

and turn the ionizer on or off. For function, use previous

 

instructions on how to control the Electronic Key Pad. To

 

use the remote, point it at the air purifier, then press and

 

release the appropriate key. The air purifier will beep once

 

to alert you that it has received the command and then it

 

will modify the appropriate setting. If the remote is not

 

working properly, first be sure that the remote is facing the

OPEN

air purfier when pressing the key. If it still does not work,

 

check the batteries.

 

2. Batteries: Install two AAA batteries (UM-4 or IEC R03 or

 

Equivalent). Refer to the printed graphics in the battery

FIGURE 2

compartment for the proper orientation of the batteries.

FORM 41505-01 Rev 6-12-2001

3

© 2001 HUNTER FAN CO.

Loading...
+ 5 hidden pages