Loading...HP 5/5M/5N MAINTENANCE KIT INSTRUCTIONS
***** WARNING *****
Turn the printer off, unplug it. And allow it to sit for 30 minutes before performing user maintenance procedures
The following parts are included in this maintenance kit
1 |
RG5-0879 |
Fusing Assembly |
1 |
RF5-0349 |
Transfer Roller |
1 |
RB1-7911 |
Main Pickup Roller |
1 |
RB1-2205 |
Tray 1 Pickup Roller |
1 |
RB1-7983 |
Lower Cassette Pickup Roller |
1 |
RF5-0343 |
Separation Pad |
Fuser Installation
1Remove the paper tray and toner cartridge from the printer.
2Open the rear door and unfasten the screws from the fuser and pull out by grabing it by its left and right metal tabs lift slightly and pull the fuser straight out of the printer.
3Place the new fuser into the printer and push it in until the screwholes line up with those in the base.
4Rescure the head screws and close the rear cover.
Transfer Roller Replacement
1Turn the printer around so the front is facing you.
2Open the top cover and locate the transfer roller.
3Using a flathead screwdriver or the green plastic loop (located on the front inside edge of the upper cover, lift the transfer roller shaft between the blue gear and the white plastic bushing.
4Lift and remove the transfer roller from the printer
5Insert the right side of the new transfer roller first, then press down on the left side until it snaps into place.
6Replace the green plastic loop if it was used in step 3
Tray 1 Pickup Roller and Separation Pad Replacement
1Open Tray 1 and locate the tray 1 pickup roller, remove it by pinching the middle clip and pulling it out of the printer.
2Using a flathead screwdriver, gently pry up on the silver edge of the separation pad and remove it.
3Snap the new separation pad into place. (The silver edge faces the front of the printer)
4Slide the new manual feed pickup roller onto the shaft until it snaps into place. It may be necessary to turn the roller while doing this.
Main Pickup Roller Replacement
1Turn the printer onto its left side
2Locate the main pickup roller on the underside of the printer. Pinch the clip on the pickup roller and remove it from the shaft.
3Slide the new main pickup roller onto the shaft until it snaps into place. It may be necessary to turn the roller while doing this.
4Return the printer to the upright position
Optional Lower Tray Pickup Roller Replacement
1Separate the optional lower tray from the printer
2Pinch the release clip on the pickup roller and pull the roller from the shaft.
3Slide the new pickup roller onto the shaft until it snaps into place. It may be necessary to turn the roller while doing this.
4Replace the paper tray and the toner cartridge.
Resetting the Maintenance Counter
1Hold down the Itemand ValueKeys while turning the printer on.
2Wait until reset maintenance count displays and then release both keys
Loading...