Hotpoint SX 636 X, SX 638 CW, SBS 638 CX, SBS 638 CW, SBS 638 CK User Manual

...
0 (0)

Operating Instructions

OVEN

 

 

 

 

 

 

 

 

Contents

 

 

 

 

GB

 

 

 

 

 

 

 

Warnings, 2

 

 

GB

 

 

 

 

Installation, 3

 

 

 

 

 

 

English,1

Positioning

 

 

 

Electrical connection, 4

 

 

 

Data plate

 

 

 

Description of the appliance, 5

 

 

 

Overall view

 

 

 

Control panel

SX 636 X

SX 638 CX SX 638 CW SX 638 CK SBS 638 CK SBS 638 CW SBS 638 CX SBS 636 X

Start-up and use, 6

Starting the oven

The electronic cooking programmer, 7

Cooking modes, 8-9

Cooking modes Practical cooking advice Cooking advice table

Precautions and tips, 10

General safety Disposal

Respecting and conserving the environment

Care and maintenance, 11

Switching the appliance off

Cleaning the appliance

Cleaning the oven door

Replacing the light bulb

After Sales Service, 12

Guarantee, 13

 

us

on

 

24

phone 24

your

 

24

 

Please08448activate

to

guarantee

Warnings

WARNING: The appliance and its accessible parts become hot during use. Care GB should be taken to avoid touching heating elements. Children less than 8 years

of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass.

Never use steam cleaners or pressure cleaners on the appliance.

WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

2

Hotpoint SX 636 X, SX 638 CW, SBS 638 CX, SBS 638 CW, SBS 638 CK User Manual

Installation

! Please keep this instruction booklet in a safe place for future reference. If the appliance is sold, given away or moved, please make sure the booklet is also passed on to the new owners so that they may benefit from the advice contained within it.

! Please read this instruction manual carefully: it contains important information concerning the safe operation, installation and maintenance of the appliance.

Positioning

!Do not let children play with the packaging material; it should be disposed of in accordance with local separated waste collection standards (see Precautions and tips).

!The appliance must be installed by a qualified professional in accordance with the instructions provided. Incorrect installation may damage property

or cause harm to people or animals.

Built-in appliances

Use an appropriate cabinet to ensure that the appliance operates properly:

The panels adjacent to the oven must be made of heat-resistant material.

Cabinets with a veneer exterior must be assembled with glues which can withstand temperatures of up to 100°C.

To install the oven under the counter (see diagram) or in a kitchen unit, the cabinet must have the following dimensions:

 

 

 

 

.

 

 

 

 

 

mm

 

 

mm.597

mm.20

mm.570

550 .

 

mm.585-575

min

 

 

 

 

 

 

 

 

 

 

.

 

 

 

 

 

mm

 

 

 

 

 

45

 

 

 

 

 

 

558

mm.

min.

 

 

 

 

 

 

 

 

 

 

 

 

595

mm.

 

.

 

mm

 

 

550

.

 

 

mm

 

 

 

.*

 

 

20,5 mm

 

 

22,5

 

* Stainless steel models only

! The appliance must not come into contact with electrical parts once it has been installed.

The indications for consumption given on the data plate have been calculated for this type of installation.

Ventilation

GB

To ensure adequate ventilation is provided, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams).

.

45

m

 

mm

 

m

.

560

 

 

 

Centring and fixing

Secure the appliance to the cabinet:

Open the oven door.

Remove the 4 rubber plugs covering the fixing holes on the perimeter frame.

Fix the oven to the cabinet using the 4 wood screws.

Replace the rubber plugs.

! All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

3

Electrical connection

GB

The electrical connection to the mains must be made on the appliance. The power voltage and frequency are as indicated on the rating plate.

! THIS APPLIANCE MUST BE EARTHED.

Connecting the power supply cable

To open the terminal board:

Using a screwdriver, press on the tabs situated on each side of the terminal board cover.

Pull open the terminal board cover.

To connect the power supply cable, proceed as follows:

Unscrew the cable clamp screw and the contact screws L-N- .

Fasten the wires beneath the screwheads using the following colour scheme: Blue (N) Brown (L)

Yellow-Green

Fasten the power supply cable in the corresponding cable clamp and close the cover.

Electrical Connection:

Voltage Frequency: 230

V-1+N 50Hz

Fuse Section: 16A

Supply cable: 3x1.5mm2

4

2

N

L

You can connect your oven to the system means of a terminal board. Refer to above information for the minimal cable sections and the calibration of the protective elements according to the connection.

If the appliance is installed with a junction box, an omnipolar circuit breaker - with a minimum contact opening of 3mm - should be installed between the appliance and the mains.

Power cable supply connection to the electrical mains:

We recommend you use a power supply cable which is long enough to allow you to take the oven out of its recess in the event of maintenance operations (only use HAR - H 05 - RRF quality cables fitted with a plug conforming to the regulations in force.

The plug must be accessible at all times.

Unplug the appliance before all operations, even when replacing the oven lamp.

Using the appliance without correct earthing is highly dangerous.

! After connecting the appliance to the flexible cable, tighten all the screws on the terminal board.

APPLIANCE SPECIFICATIONS

Dimensions

width 43.5 cm

height 32 cm

 

depth 41.5 cm

Volume

58 l

Electrical

Voltage at 220-240 V~ 50/60 Hz or

50 Hz (see data plate)

connections

maximum power absorbed 2800 W

 

Directive 2002/40/EEC on the

 

label of electric ovens.

 

Standard EN 50304

ENERGY

Energy consumption for Natural

convection – heating mode:

LABEL

Traditional mode

 

Declared energy consumption

 

Forced convection class -

 

heating mode:

 

Baking.

 

This appliance conforms to the

 

following EEC Directives:

 

2006/95/EEC dated 12/12/06

 

(Low Voltage) and subsequent

 

amendments - 2004/108/EEC

 

dated 15/12/04 (Electromagnetic

 

Compatibility) and subsequent

 

amendments - 93/68/EEC dated

 

22/07/93 and subsequent

 

amendments. 2002/96/EEC

 

and subsequent amendments.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

4

Description of the appliance

Overall view

GB

Control panel

GUIDES for the

 

sliding racks

GRILL

position 5

 

position 4

DRIPPING PAN

position 3

position 2

 

 

position 1

Control panel

SELECTOR

 

 

 

 

 

 

 

 

 

 

THERMOSTAT

 

 

 

 

THERMOSTAT

 

 

knob

 

 

 

 

 

 

 

 

 

 

indicator light

 

 

 

 

knob

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

ELECTRONIC programmer*

* Only available in certain models.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

5

Loading...
+ 11 hidden pages