RB758DP– Hotpoint 30" Free-Standing Electric Range
Dimensions (in inches)
29-7/8 |
7-1/2 |
7-1/2 |
|
7 |
|
||
|
|
|
|
|
|
|
5 |
|
REAR |
3-1/2 |
2-1/4 |
|
|
||
|
WALL |
|
|
|
2-1/4 |
CENTER LINE |
|
|
|
|
46-1/8
1/4†
†The range may be placed with 0" clearance (flush) at the back wall and side walls if the range side trims extend beyond the cabinet fronts at least 1/4". Self-Clean models only
26-3/8*
46-3/8
*Dimension from wall to front of closed oven door. Dimension from wall to the front of closed oven door handle is 28-1/2".
Specification Revised 4/09
Amp Rating
240V 11.7
208V 8.8
Breaker Size
40 Amps†
†Note: Check local codes for required breaker size.
Effective January 1, 1996, the National Electrical Code requires that new construction (not existing) utilize a 4-conductor connection to an electric range.
Note: 30" Electric Ranges conform to U.L. requirements for
0" spacing from walls below countertops. Allow 1-1/2" spacing from the side of the range to adjacent vertical walls above the cooktop surface.
Receptacle Locations: Locally approved flexible service cord or conduit must be used because terminals are not accessible after range installation . See shaded area in drawing for location of electrical outlet box. Recommended outlet locations allow range to be installed directly against rear wall.
Installation Information: Before installing, consult installation instructions packed with product for current dimensional data.
All Hotpoint ranges are equipped |
|
with an Anti-Tip device. The |
Listed by |
installation of this device is an |
|
important, required step in the |
Underwriters |
installation of the range. |
Laboratories |
420410
Loading...