Hotpoint KSO103PX S, SH103PX S User Manual

0 (0)

SH103PX S

KSO103PX S

English

Operating Instructions

OVEN

Contents

 

Operating Instructions,1

Warnings,2

Description of the appliance,3

Installation,4

Electrical Connection,4

Start-up and use,6

Modes,7

Precautions and tips,11

Maintenance and care,11

Troubleshooting,14

Afetr Sales Service,15

Guarantee,16

 

us

on

 

24

phone 24

your

 

24

 

Please08448activate

to

guarantee

GB Warnings

WARNING: The appliance and its accessible parts become hot during use. Care should be taken to avoidtouchingheatingelements.Childrenlessthan8 years of age shall be kept away unless continuously supervised. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision.

Do not use harsh abrasive cleaners or sharp metal scrapers to clean the oven door glass since they can scratch the surface, which may result in shattering of the glass.

Never use steam cleaners or pressure cleaners on the appliance.

WARNING: Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock.

Before initiating the automatic cleaning cycle:

clean the oven door;

remove large or coarse food residues from the inside of the oven using a damp sponge. Do not use detergents;

remove all accessories and the sliding rack kit (where present);

do not place tea towels

Keep children away from the appliance during the automatic cleaning cycle as surfaces may become very hot.

! When you place the rack inside, make sure that the stop is directed upwards and in the back of the cavity.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

2

Description of the appliance

Overall view

1.POSITION 1

2.POSITION 2

3.POSITION 3

4.POSITION 4

5.POSITION 5

6.GUIDES for the sliding racks

7.DRIPPING PAN

8.GRILL

9.Control panel

Control panel

1.MANUAL COOKING MODE Icons

2.FAST CLEAN selector

3.TEMPERATURE display

4.TEMPERATURE icon

5.DURATION icon

6.TIME display

7.END OF COOKING Icon

8.CONTROL PANEL LOCK icon

9.START / STOP

10.LIGHT icon

11.CLOCK icon

12.MINUTE MINDER Icon

13.TIME / TEMPERATURE ADJUSTMENT Icons

14.PREHEATING / RESIDUAL HEAT icons

15.DOOR LOCK indicator

16.AUTOMATIC/ECO COOKING MODE icons

17.CONTROL PANEL POWER BUTTON

GB

9

6

8

5

 

4

7

3

 

2

 

1

1

2

3

4

5

6

7

8

17

16

15

14

13

12

11

10

9

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

3

Hotpoint KSO103PX S, SH103PX S User Manual

GB Installation

!Please keep this instruction booklet in a safe place for future reference. If the appliance is sold, given away or moved, please make sure the booklet is also passed on to the new owners so that they may benefit from the advice contained within it.

!Please read this instruction manual carefully: it contains important information concerning the safe operation, installation and maintenance of the appliance.

Positioning

!Do not let children play with the packaging material; it should be disposed of in accordance with local separated waste collection standards (see Precautions and tips).

!The appliance must be installed by a qualified professional in accordance with the instructions provided. Incorrect installation may damage property or cause harm to people or animals.

Built-in appliances

Use an appropriate cabinet to ensure that the appliance operates properly:

The panels adjacent to the oven must be made of heat-resistant material.

Cabinets with a veneer exterior must be assembled with glues which can withstand temperatures of up to 100°C.

To install the oven under the counter (see diagram) or in a kitchen unit, the cabinet must have the following dimensions:

 

 

 

.

 

23 mm.

 

.min

mm.595

mm.567

mm

585-575mm.

 

 

 

547

 

 

558

mm.

 

 

 

595

 

5 mm.

 

mm.

.

 

 

mm

 

 

 

545

 

 

.

 

 

 

mm

 

 

25

 

 

! The appliance must not come into contact with electrical parts once it has been installed. The indications for consumption given on the data plate have been calculated for this type of installation.

Ventilation

To ensure adequate ventilation, the back panel of the cabinet must be removed. It is advisable to install the oven so that it rests on two strips of wood, or on a completely flat surface with an opening of at least 45 x 560 mm (see diagrams).

Centring and fixing

Secure the appliance to the cabinet by opening the oven door and inserting 4 screws into the 4 holes on the outer frame.

! All parts which ensure the safe operation of the appliance must not be removable without the aid of a tool.

Electrical Connection

The electrical connection to the mains must be made on the appliance. The power voltage and frequency are as indicated on the rating plate.

! THIS APPLIANCE MUST BE EARTHED.

Fitting the power supply cable

L

N

1. Open the terminal board by inserting a screwdriver into the side tabsofthecover.Usethescrewdriver as a lever by pushing it down to open the cover (see diagram)

.

2. Install the power supply cable by loosening the cable clamp screw and the three wire contact screws

L-N-.

Connect the wires to the corresponding terminals: the Blue wire to the terminal marked (N), the Brown wire to the terminal marked

(L) and the Yellow/Green wire to the terminal marked (see diagram).

3.Secure the cable by fastening the clamp screw.

4.Close the cover of the terminal board.

.

45

mm.

mm

 

560

 

 

Electrical Connection:

Voltage Frequency: see data plate

Fuse Section: 16A

Supply cable: 3x1.5mm2

You can connect your oven to the system means of a terminal board. Refer to above information for the minimal cable sections and the calibration of the protective elements according to the connection.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

4

If the appliance is installedwith a junction box,anomnipolar circuit breaker

- with a minimum contact opening of 3mm - should be installed between the appliance and the mains.

Powercablesupplyconnectiontotheelectricalmains:

We recommend you use a power supply cable which is long enough to allow you to take the oven out of its recess in the event of maintenance operations

(only use HAR - H 05 - RRF quality cables fitted with a plug conforming to the regulations in force.

The plug must be accessible at all times.

Unplug the appliance before all operations, even when replacing the oven lamp.

Using the appliance without correct earthing is highly dangerous.

!Afterconnectingtheappliancetotheflexiblecable,tightenallthe screws on the terminal board.

!The cable must be checked regularly and replaced by authorised technicians only (see Assistance).

APPLIANCE SPECIFICATIONS

GB

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Dimensions*

width 43.5 cm

 

 

height 32,4 cm

 

 

 

 

 

 

 

 

 

 

 

depth 41.5 cm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Volume*

59 l

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Dimensions**

width 45.5 cm

 

height 32,4 cm

 

 

 

 

 

 

 

 

 

 

 

depth 41.5 cm

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Volume**

62 l

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Electrical

voltage: 230-240V~ 50/60Hz or 50Hz

 

(see data plate)

 

connections

maximum power absorbed

 

 

 

 

 

 

 

 

 

 

 

2800-3000 W

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Directive 2002/40/EC on the label

 

 

 

 

 

 

 

 

 

 

 

of electric ovens. Standard EN 50304

 

ENERGY

Declared energy consumption

 

LABEL

for Forced convection Class –

 

 

 

 

 

 

 

 

 

 

 

heating mode:

 

 

 

 

 

 

 

 

 

 

 

ECO.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

*Only for models with drawn rails.

**Only for models with wire rails.

PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24

5

Loading...
+ 11 hidden pages