INSTALL INSTRUCTIONS for KK-F-VAK
FORD VAN REAR AIR VENT ADAPTER KIT
TOOLS REQUIRED: |
|
|
||
Ratcheting wrench |
|
Screwdriver set |
||
Standard & Metric Socket Set |
|
Wire cutters |
||
HARDWARE: |
|
|
||
QTY |
DESCRIPTION |
|
PART # |
|
1 |
Heat/Cool Adaptor box assembly |
KKM01152 |
||
1 |
Ford Rear Air Hose Adapter |
KKM01153 |
||
1 |
Ford Heat/Cool Box mounting channel |
KKM99071 |
||
10 |
Hose Clamps 3” |
|
GSM20045 |
|
2 |
4” Hose Clamps |
|
GSM20042 |
|
4’ |
4” Diameter Hose |
|
GSM40100 |
|
4 |
Vent cover w/ hose adapter assembly |
KKM0403-001 |
||
1 |
2 |
½” “Y” Duct Connector |
PRM97483 |
|
1 |
2 |
½” Air Duct Hose |
8 foot length |
PRM97475 |
1 |
2 |
½” Air Duct Hose |
7 foot length |
PRM97475 |
1 |
2 |
½” Air Duct Hose |
6 foot length |
PRM97475 |
2 |
2 |
½” Air Duct Hose |
4 foot length |
PRM97475 |
20 |
#10 X ¾” Sheet Metal Screws |
GSM33195 |
||
20 |
#10 Star Washers |
|
GSM31034 |
|
20 |
#10 x ¾” Flat Head Sheet Metal Screws |
GSM34151 |
||
20 |
15” Wire Tie |
|
GSM20036 |
¾Read all instructions before installing any Havis-Shields Equipment Corp products.
¾Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
¾Use hardware provided with install kit
¾For product support, visit the Install Instructions Section of our website at http://havis.com/Installation/Installation.html, email technicalsupport@havis.com or call 1-800-524-9900.
Remove the hex head screw on |
Remove the vent cover |
Remove the hex head lag bolt |
the vent cover |
completely. It will not be re-used. |
located above the blower motor of |
|
|
the OEM rear HVAC unit |
Remove the hex head lag bolt |
Remove the hex head screws on |
Remove the intake cover. |
holding the intake cover of the |
the intake cover |
Intake cover will not be re-used. |
OEM rear HVAC unit |
|
|
Attach the HVAC hose and clamps to the plenum assembly
View of the components at this |
Place the unit as shown above |
point of the installation |
|
2 |
KK-F-VAK_INST_10-08 |