Installation Instructions / Warranty
Raindance Showerpanel |
27005XX1 |
Raindance Showerpanel |
27005XX1 |
Technical Data
Operating pressure: |
max.145 psi |
Recommended pressure: |
30 - 60 psi |
Test pressure: |
232 psi |
Max. hot water temp.: |
176° F* |
Recommended hot water temp.: 120°F - 140°F*
Flow rate @ 45 psi |
|
Handshower |
2.5 gpm |
Bodysprays |
<1 gpm each |
Protection against back siphonage is provided by check valves in the hot and cold supply elbows.
This panel incorporates a thermostatic mixing valve. The high temperature limit stop on the mixing valve can be reset to comply with local plumbing codes. See page 10.
*Know and follow all applicable local plumbing codes when setting the temperature on the water heater.
Preparation for Installation
Install 1/2” IPS nipples for the hot and cold water supplies at the locations shown on the diagram. The nipples should extend 5/8” outside the surface of the finish wall.
For proper operation of the unit, the hot supply should be on the left, and the cold supply should be on the right.
Install the wall surface material. Make sure that the wall is watertight before installing the panel.
Seal the wall around the nipples with waterproof sealant.
Installation
Wrap the nipples with several layers of Teflon tape.
Install the elbows included with the panel. The outlets should point downwards. The elbow should extend no more than 1 1/4” from the surface of the finished wall.
With a helper holding the panel in place, mark the positions of the screw holes.
Set the panel aside, securely supported to prevent damage.
Drill the screw holes with a 6 mm bit suitable for the wall surface.
Install the anchors. Seal the wall around the anchors with waterproof sealant.
Hold the panel against the wall.
Install the gray plastic insert.
Insert the top screw through the front of the panel, the washer and the insert. Screw it into the anchor.
Loading...