Haier DW12-EGAN, DW12-2, E12-AFM2, ELDW-12, DW-FU12 User Manual

...
5 (1)

Domestic Dishwasher

WQP12-AFM2

GB

`çÇÉW=MNOMRMQMPO^

Safety Is a Good Habit to Get Into

NOTICE

Carefully read the instructions contained in this manual,as they provide important information which is essential to safe and proper installation, use and maintenance of the appliance.

This appliance complies with the following EEC

directives:

-73/23/EEC of 19/02/73(Low Voltage)and subsequent modifications;

-8 9 / 3 3 6 / E E C o f 0 3 / 0 5 / 8 9 ( E l e c t r o m a g n e t i c Compatibility) and subsequent modifications.

-Carefully dispose of the packing material.

-After removing the packing,check to make sure that the appliance is not damaged.If in doubt,contact a qualified professional.

-The dishwasher must only be used by adults for the washing of household dishes and cooking utensils.

-Fundamental rules to follow when using the appliance:

*Never touch the dishwasher when bare foot or with wet hands or feet;

*We discourage the use of extension cords and multiple sockets;

*During installation,the power supply cord must not be excessively or dangerously bent or flattened;

* If the appliance is not operating properly or maintenance must be performed,disconnect the appliance from the power supply.

-Keep detergents out of the reach of children,who must also be kept away from the dishwasher when it is open.

-This appliance cannot be installed outdoors,not even if the area in which it is installed is covered by a roof;it is also very dangerous to leave it exposed to the rain and elements.

-Do not touch the heating element during or after a wash cycle.

-Do not lean or sit on the door when it is open ,as this could overturn the dishwasher.

-If the appliance malfunctions,turn off water supply to the appli ance and disconnect the plug from the wall socket.Then,con sult the section entitled, "Troubleshooting."If you cannot solve the problem,contact a service centre.

-Only specialised personnel are authorised to make repairs.

-Appliances which are no longer being used must be made inoperable by cutting the power supply cord and removing the

door lock.

-The appliance must be positioned so that the plug is accessible.

-The carpet must obstruct the opening when the appliance installing on the ground with carpet.

-If the supply cord is damaged , it must be replaced by a special cord or assembly available from the manufacturer or its service agent.

Close-up View (control panel)

A B C

 

F

E

 

D

A

ON-OFF Light

 

D

Knob For Selecting Cycle

B

ON-OFF Button

 

E

Handle For Opening Door

C

Low Salt Indicator Light

 

F

"Eco" Button

.1.

GB

Haier DW12-EGAN, DW12-2, E12-AFM2, ELDW-12, DW-FU12 User Manual

Close-up View (Interior)

A

Upper Rack

E

Bottom Spray Arm

B

Rack Height Adjustor

F

Washing Filter

C

Top Spray Arm

G Detergent and Rinse Aid Dispenser

D

Lower Rack

H

Salt Container Cap

Technical characteristics

Width

60 cm

 

 

Depth

60 cm

 

 

Height

85 cm

 

 

Capacity

12 standard place settings

 

 

Mains water pressure

0.03-0.6 MPa

 

 

Power voltage

220-240V~ 50Hz

 

 

Total absorber power

2100W

 

 

.2.

GB

S a l t

Salt

The hardness of the water varies from place to place. If hard water is used in the dishwasher,deposits will form on the dishes utensils.

The appliance is equipped with a special softener that uses a salt specifically designed to eliminate lime and minerals from the water.

Loading the Salt into the Softener

Always use salt intended for use with dishwashers.

The salt container is located beneath the lower rack and should be filled as follows:

-Remove the lower rack and then unscrew and remove the cap from the salt container;

-If you are filling the container for the first time, fill it with water;

-Place the end of the funnel(supplied) into the hole and introduce about 2 kg of salt.It is normal for a small amount of water to come out of the container.

-Carefully screw the cap back on.

The salt container should be filled after about every 30 wash cycles.

To prevent the formation of rust,load the salt just before beginning a wash cycle.

Adjusting Salt Consumption

The dishwasher is equipped with a system to adjust the level of salt consumption in function of the hardness of the water being used in order to optimize and customize the level of salt consumption while keeping it to a minimum.

To adjust salt consumption level , follow these instructions:

-Unscrew the cap on the salt container;

-On the container there is an arrow (see figure to the side).If necessary,turn the arrow in the anti-clockwise direction from the "-" setting to the "+" setting based on the hard ness of the water being used.

-It is highly recommended that the table be consulted when making adjustments .

Water Hardness

 

 

 

 

 

 

 

 

 

 

 

 

 

Selector

Salt

Autonomy

Clarke

ºdH

mmol/l

c o n s u m p t i o n

degrees

position

(cycles/2kg)

 

 

(Grams/cycle)

0 14

M NT

M NIT

L

M

L

NQ PS

NU QQ

NIU QIQ

=?J?

OM

SM

 

 

 

 

 

 

PS TN

QR UV

QIR UIV

jba

QM

QM

 

 

 

 

 

[TN

[UV

[UIV

?H?

SM

OR

 

 

 

 

 

 

.3.

GB

Loading...
+ 8 hidden pages