GE Appliances
WSM2420/80D – GE® 24” Unitized Spacemaker® Washer/Dryer
Dimensions (in inches)
27-5/8
71-3/4
32-1/2
27-1/4
23-7/8
21-5/16 8
27-5/8
Distance from vent
to back 4-1/2"
32-1/8
|
71-3/4 |
|
1-1/2 |
27-1/2 |
38 |
28-5/8 |
|
Drain |
Water |
|
inlet- |
|
cold |
27-1/4 |
23-7/8 |
Floor line |
|
|
1" For leveling legs
Power Cord Location
Electrical Requirements:
WSM2420D:
Electric Dryer –This appliance should be connected to an individual, properly grounded branch circuit with 120/240V single-phase 60Hz electrical service and should be protected by 30-amp time-delay fuses or circuit breakers. This appliance is manufactured with the neutral connected to the frame. Power cord should be purchased separately.
Note: These appliances are not approved for 120-volt operation.
WSM2480D:
Gas Dryer – This appliance should be connected to an individual, properly grounded branch circuit with a three-prong grounding-type receptacle and 120-volt single-phase 60 Hz electrical service and should be protected by 15- or20-amp time-delay fuses or circuit breakers. This appliance is equipped with a 6-foot long flexible U.L. listed 20-amp power cord to match a 15-amp receptacle.
Gas Rated input 10,500 BTU/HR. Factory equipped for natural gas. Tested for LP gas.
Dryers must be exhausted to the outside.
Installation Information:
For complete information, see installation instructions packed with the product.
Power Cord Hole
9-1/2
41-1/2
|
|
|
|
|
|
Specification Revised 5/09 |
|
|
|
|
|
|
Back View |
|
|
||
360327 |
|
|
|
|
|
|
|
|
|
|
Listed by Underwriters Laboratories
For answers to your Monogram,® GE Profile™ or GE® appliance questions, visit our website at GEAppliances.com or call
GE Answer Center® service, 800.626.2000.