Frigidaire FGDS3075K W-B User Manual

752.76 Kb


FGDS3075K W/ B

30" Dual-Fuel

Effortless Performance

Auto Shut-OffQuick Clean Option

Effortless™ Convection Conversion Power Broil ( 4,000W )


Effortless™ Oven Rack


Continuous Cast Iron Grates with Black Matte Finish

Even Baking Technology

SpaceWise™ Design

Keep Warm Drawer with SpaceWise™ Half Rack

SpaceWise™ Half Rack


Chicken Nuggets Pizza

Keep Warm


Signature Features

More Easy-To-UseFeatures

Delay Start

Hidden Bake


A.D.A. Compliant*

Sabbath Mode (Star-K®Certified)


4.2 Cu. Ft. Oven Capacity

1.6 Cu. Ft. Drawer Capacity

Overall Exterior Dimensions







Available in:

Quick Preheat

True Convection



Preheat in less than six minutes.1

Multi-rackbaking is faster and more



even with True Convection.


White Black

(W) (B)

*  When properly installed, meets the appliance standards in the American with Disabilities Act and the Architectural Barriers Act Accessibility Guidelines as published by the United States Access Board on June 23, 2004.

1Based on single rack cooking performance, not set temperature, using Quick Preheat.

Quick Boil


Boil water faster with our

Easily go from warm to boil.



FGDS3075K W/ B 30" Dual-Fuel

Slide-InRange Specifications

Product Shipping Weight (approx.) – 260 Lbs.

Single phase 3- or 4-wirecable, 120 / 240 or 120 / 208 Volt,

60 Hertz, fused on both sides of line with ground. (If local code permits, range may be connected by hard-wiring or by means of power supply cord kit.)

Connected Load (kW Rating) @ 240 / 208 Volts = 5.6 / 4.2 kW

Amps @ 240 / 208 Volts = 23 / 20 Amps

Always consult local and national electric and gas codes.

Range ships with 3/4" factory regulator.

LP Gas conversion kit supplied.

Gas supply piping can be routed through side wall of right cabinet. Right side cabinet is ideal location for main shutoff valve.

Countertop Preparation

For detailed preparation instructions, refer to installation guide on the web.

Flat square-finish(flat) countertop requires no preparation since rangetop flange lays directly on countertop edge.

Formed front-edgedcountertops require front molded edge to be shaved flat 3/4" from each front corner of opening.

Tile countertops may need cut back 3/4" from each front corner of opening and /or rounded edge flattened.

For existing cutout width greater than 30-1/16"reduce the 3/4" overlap dimension or for cutout width of 29", replace actual side trim panels with smaller side trim panels, available with optional Side Trim Kit(refer to detailed kit installation instructions).

Countertop MUST be level in all directions and adjustable range height at least 1/16" greater than tallest cabinet height, to ensure metal rangetop flange will fit properly on countertop edge.

When installing optional Backguard Kit, cutout depth of 21-3/4"minimum / 22-1/8"maximum needs increased to 24".

Overhead cabinetry should not exceed a 13" maximum depth.

Absolute minimum horizontal distance between overhead cabinets installed to either side of appliance must be no less than maximum width of appliance.

Allow 24" minimum clearance between rangetop and bottom of cabinet when bottom of wood or metal cabinet is protected by not less than 1/4" flame-retardantmillboard covered with not less than No. 28 MGS sheet steel, 0.015" stainless steel, 0.024" aluminum or 0.020" copper. Allow 30" minimum clearance when cabinet is unprotected.

Allow 5" minimum clearance from edge of rangetop to nearest combustible wall on either side of unit.

To reduce risk of fire when using overhead cabinetry, install range hood that projects horizontally a recommended minimum of 5" beyond bottom of cabinets.


Note: For planning purposes only. Refer to Product Installation Guide on the web at for detailed instructions.

Optional Accessories

Rear Filler Kit: Stainless Steel – (PN # 901193-901S),White – (PN #901193-9011),Black – (PN #901193-9010).

Side Panel Kit: Stainless Steel – (PN # 903074-901S),White – (PN #903074-9011),Black – (PN #903074-9010).

Backguard Kit: Stainless Steel – (PN # 903046-901S),White – (PN #903046-9011),Black – (PN #903046-9010).

Side Trim Kit: Stainless Steel – (PN # 903075-901S),White – (PN #903075-9011),Black – (PN #903075-9010).

USA 250 Bobby Jones ExpresswayMartinez, GA


CANADA 5855 Terry Fox WayMississauga, ON L5V

subject to change.

FGDS3075K 05/09

© 2009 Electrolux Home Products, Inc.

Printed in the U.S.A.