Rack Mount
The GLI 1000 unit can be mounted to the rear of a flat 2U rack panel (also a 1U rack panel for the 2RCA and 2BNC models) or the front of a recessed rack panel (not shown) using four 6-32 x 3/8 screws.
Projector Mount
Secure the optional mounting bracket to the GLI 1000 using the four #8 machine screws already installed in the side of the GLI. Secure the GLI to the projector mount by inserting the mounting bolt through the slotted hole in the bracket. (See figure on reverse.)
Surface Mount
Secure both optional mounting brackets to the GLI 1000 using the eight #8 machine screws already installed in the sides of the GLI. Drill four 3/32” pilot holes, 1/4” deep in the mounting surface. Secure the GLI to the surface with four #8 wood screws. (See figure on reverse.)
GLI 1000 Installation Instructions
Extron
GLI 1000 2RCA
Rack Mount 2RCA
1000
5BNC
Extron
H
GLI 1000 2BNC
Extron
GLI 1000 HD
Extron
GLI 1000 BNC
Ground Loop Inhibitor
|
|
Extron Electronics, USA |
|
Extron Electronics, Europe |
|
Extron Electronics, Asia |
|
Extron Electronics, Japan |
|
|
|
|
1230 South Lewis Street |
|
Beeldschermweg 6C |
|
135 Joo Seng Road, #04-01 |
|
Daisan DMJ Building 6F |
|
|
|
|
Anaheim, CA 92805 |
|
3821 AH Amersfoort |
|
PM Industrial Building |
|
3-9-1 Kudan Minami |
|
68-662-01 |
|
|
USA |
|
The Netherlands |
|
Singapore 368363 |
|
Chiyoda-ku, Tokyo 102-0074 Japan |
||
www.extron.com |
|
714.491.1500 |
|
+31.33.453.4040 |
|
+65.6383.4400 |
|
+81.3.3511.7655 |
|
Rev. A |
|
Fax 714.491.1517 |
|
Fax +31.33.453.4050 |
|
Fax +65.6383.4664 |
|
Fax +81.3.3511.7656 |
Printed in the USA |
||
|
|
|
|
|||||||
|
|
|
|
|
|
|
|
|
GLI 1000 Installation Instructions (Cont’d)
Extron
RGB 109xi
Interface
Computer
Ceiling
Digital Projector
Projector
Mount
Projector
Mounting
Bracket
Mounting
Bolt
Extron
GLI 1000 HD
Surface
Mount Mounting Screws (2 Plcs)
Each Side
Drill pilot holes __ 3/32" (2.4mm) diam. 1/4" (6.3mm) deep
#8 Screws (4 Plcs)
Each Side
Table/Wall-mount
Bracket (for wall-mount, rotate bracket 90˚ before installing)