Electro-Voice VARIPLEXII User Manual

Biamp: Two Amp Channel System

Variplex II

TM

Crossover Installation

Instructions

To Amp (500 Hz - 20 kHz)

Mid/HF

Step 1 - Place jumper in “Passive Mode” on

Variplex horn input panel

Step 2 - Connect LF amp channel to “Input” on

TL606ST input panel

Step 3 - Connect Mid/Hi amp channel to “Passive

Mode” on Variplex horn

Triamp: Three Amp Channel System

Step 1 - Place jumper in “Active Mode” on

Variplex horn input panel

Step 2 - Connect LF amp channel to “Input” on

TL606ST input panel

Step 3 - Connect Mid amp channel to “Active Mid

Input” on Variplex horn

Step 4 - Connect High amp channel to “Active HF

Input” on Variplex horn

Jumper in Passive Mode

Jumper in Active Mode

To Amp (20 Hz - 500 Hz)

LF

To Amp (1.25 kHz - 20 kHz)

HF

To Amp (500 Hz - 1.25 kHz)

Mid

To Amp (20 Hz - 500 Hz)

LF

12000 Portland Avenue South, Burnsville, MN 55337
Phone:[phone], Fax:[phone]

www.electrovoice.com

© Telex Communications, Inc. 1/2004

Part Number 38110-336 Rev A

U.S.A. and Canada only. For customer orders, contact Customer Service at:

800/392-3497 Fax: [phone]

Europe, Africa, and Middle East only. For customer orders, contact Customer Service at:

+ 49 9421-706 0 Fax: + 49 9421-706 265

Other International locations. For customer orders, contact Customer Service at:

+ 1 952 884-4051 Fax: + 1 952 736-4212

For warranty repair or service information, contact the Service Repair department at:

800/685-2606

For technical assistance, contact Technical Support at: 866/78AUDIO

Specifications subject to change without notice.