STITCH LINE
TENT SETUP INSTRUCTIONS
MODEL 2000007830
Before you begin |
|
|
|
|
|
tRead all instructions before set up. |
|
|
|
||
tSelect a level site clear of rocks, branches, and other hard or |
|
|
|||
sharp objects, to install your tent. |
|
|
|
||
WARNING: Keep clear of overhead power lines. |
|
|
|
||
tDo not set up your tent under trees because of potential lightning |
|
|
|||
strikes or falling tree limbs in inclement weather. |
|
|
|
||
tSecure with all stakes and guylines provided to prevent property |
|
|
|||
damage or personal injury. |
|
|
|
|
|
tFor best results in windy conditions, position narrow end of tent |
|
|
|||
into the wind. |
|
|
|
|
|
tDo not drop tent. |
|
|
|
|
Fig. 6 |
tDo not bounce tent bag on its end to remove tent, as these |
|
||||
actions may damage the frame. |
|
|
|
|
|
tTHIS RECREATIONAL PRODUCT REQUIRES A MINIMUM OF TWO |
|
|
|||
PEOPLE TO ASSEMBLE. |
|
|
|
|
|
tUnder no circumstances should this product be used to cover |
|
|
|||
automobiles, marine products or similar items. |
|
|
|
||
CAUTION: Avoid pinch points when opening and closing the |
|
|
|||
tent frame. |
|
|
|
|
|
Description |
Repair Kit |
Description |
Repair Kit |
|
|
Plastic Clip 16 mm |
5010000845 |
Plastic Corner Joint |
5010000851 |
|
|
Plastic Clip 20 mm |
5010000846 |
Fabric Joint Cover |
5010000856 |
|
|
Fabric Repair Kit |
5010000852 |
|
|
|
Fig. 5 |
|
|
|
|
|
|
Extend the Tent Frame |
|
|
Verify Connections |
||
1 ttop.Stand(Fig.the1)tent upright with the hub assembly at the |
3 |
between Tent and |
|||
the ground. (Fig. 2) |
|
|
Frame Poles |
||
tUnfold the arms of the tent downward until they lay flat on |
|
|
|
|
tVerify the clips along the edges of the tent are properly |
|
|
|
attached to the frame poles. (Fig. 7 and Fig. 8) |
2 |
Fig. 1 |
Fig. 2 |
|
Raise the Tent |
|
|
|
tUnfold the arm joints located at each of the tent corners. |
|
||
The tent will raise as the leg poles are extended. |
|
|
|
(Fig. 3 and 4) |
|
Fig. 7 |
|
|
tExtend each of the telescoping leg poles until they snap |
||
|
into place. (Fig. 5 and 6) |
|
|
Pole
Clip
Fig. 4
Fig. 8
Fig. 3 |
(continued on other side) |