Cisco uBR10012 Universal Broadband Router
Fan Assembly Module
Document Part Number: OL-5093-01
October 2003
Product Numbers: UBR10-FAN-ASSY=, UBR10-FAN-CAB=
Revision History
Date |
Revision |
Reason |
|
|
|
08/31/2001 |
78-11491-01 |
Original publication. This document is obsolete. |
|
|
|
10/21/03 |
OL-5093-01 |
Moved document to online only, updated information and format. |
|
|
|
The purpose of this document is to provide installation, removal, and troubleshooting information for the fan assembly module installed in the Cisco uBR10012 universal broadband router.
This document is intended for use by a field service engineer who is familiar with Cisco products and headend cable installation procedures.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030.
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Copyright © 2003 Cisco Systems, Inc. All rights reserved.
This document includes procedures for installing and removing the fan assembly module that comes with the Cisco uBR10012 universal broadband router. This document also includes technical specifications and troubleshooting information.
•Feature Overview, page 2
•Part Numbers and Technical Specifications, page 4
•Safety Warnings, page 5
•Removing and Replacing the Fan Assembly Module, page 9
•Replacing the Fan Assembly Cable, page 11
•Troubleshooting the Fan Assembly, page 13
•Related Documentation, page 14
•Obtaining Documentation, page 14
•Obtaining Technical Assistance, page 16
•Obtaining Additional Publications and Information, page 17
The Cisco uBR10012 universal broadband router uses a fan assembly module (Figure 1 on page 3) containing four fans to supply cooling air to the chassis.
The fan assembly is located at the top of the chassis and is connected to the chassis with a blind mate connector that plugs into a cable assembly and then into the chassis backplane.
Four internal fans draw cooling air into the front of the chassis and direct it across the internal components to maintain an acceptable operating temperature. The air is exhausted through openings in the rear of the chassis.
The fan assembly module works at variable speeds:
•Low speed (with a clean air filter): approximately 280 cubic feet per minute (cmf)
•High speed (with a clean air filter): approximately 450 cmf
The operating speed is determined by the fan assembly module. If the temperature at the fan’s outlet gets to 40°C, then the blower starts to increase the speed of the fans. It does not reach high speed, however, until the temperature at the outlet reaches 50°C.
Three LEDs (System OK, Single Fan Failure, and Multi-Fan Failure) located on the front of the fan assembly indicate the status of the fans (see Table 1 on page 3).
Figure 1 on page 3 shows the fan assembly module.
Cisco uBR10012 Universal Broadband Router Fan Assembly Module
2 |
OL-5093-01 |
|
|
Figure 1 Fan Assembly Module
Fan assembly
CISCO |
|
10000 |
CISCO |
|
10000 |
56413
Table 1 |
Fan Assembly LEDs and Their Function |
||
|
|
|
|
LED |
|
Status |
Description |
|
|
|
|
System OK |
|
Green |
System is functioning normally; all fans are operating. |
|
|
|
|
Single Fan Failure |
Yellow |
A single fan has failed; system triggers alarms, but the fan assembly |
|
|
|
|
is still able to properly cool the chassis. Repair or replace the fan |
|
|
|
assembly immediately. |
|
|
|
|
Multi-Fan Failure |
Yellow |
Two or more fans have failed, and if the operating temperature |
|
|
|
|
inside the chassis rises too high, the system automatically shuts |
|
|
|
down. Repair or replace the fan assembly immediately. |
|
|
|
|
Cisco uBR10012 Universal Broadband Router Fan Assembly Module
|
OL-5093-01 |
3 |
|
|
|
Table 2 lists the specifications for the Cisco uBR10012 universal broadband router fan assembly module.
Table 2 Cisco uBR10012 Fan Assembly Module Specifications
Description |
Specifications |
|
|
Product number (fan assembly) |
UBR10-FAN-ASSY= |
|
|
Product number (cable) |
UBR10-FAN-CAB= |
|
|
Dimensions |
• Height: 5.60 in. (14.22 cm) |
|
• Width: 19 in. (482.26 cm) |
|
• Depth: 16.15 in. (41.02 cm) |
|
|
Weight |
30 lb (13.61 kg) |
|
|
AC-input voltage and frequency |
110 to 240 VAC, 50 to 60 Hz |
|
|
Power consumption |
250 Watts (4 amps, not to exceed 6 amps at startup) |
|
|
Airflow |
Low speed (with clean air filter): 280 cfm1 |
|
High speed (with clean air filter): 450 cfm |
|
|
MTBF |
• Fans, 248,509 hours |
|
• Fan Control, 596,65 hours |
|
|
Temperature range |
• Operating: 41 to 104°F (5 to 40°C) |
|
• Storage: –40 to 158°F (–40 to 70°C) |
|
|
Relative humidity |
• Operating: 5 to 85% |
|
• Storage: 5 to 95% |
|
|
Operating altitude |
–197 to 13,123 ft (–60 to 4000 m) |
|
|
1. Cubic feet per minute
Cisco uBR10012 Universal Broadband Router Fan Assembly Module
4 |
OL-5093-01 |
|
|
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for preventing accidents. Use the statement number provided at the end of each warning to locate its translation in the translated safety warnings that accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
Waarschuwing BELANGRIJKE VEILIGHEIDSINSTRUCTIES
Dit waarschuwingssymbool betekent gevaar. U verkeert in een situatie die lichamelijk letsel kan veroorzaken. Voordat u aan enige apparatuur gaat werken, dient u zich bewust te zijn van de bij elektrische schakelingen betrokken risico's en dient u op de hoogte te zijn van de standaard praktijken om ongelukken te voorkomen. Gebruik het nummer van de verklaring onderaan de waarschuwing als u een vertaling van de waarschuwing die bij het apparaat wordt geleverd, wilt raadplegen.
BEWAAR DEZE INSTRUCTIES
Varoitus TÄRKEITÄ TURVALLISUUSOHJEITA
Tämä varoitusmerkki merkitsee vaaraa. Tilanne voi aiheuttaa ruumiillisia vammoja. Ennen kuin käsittelet laitteistoa, huomioi sähköpiirien käsittelemiseen liittyvät riskit ja tutustu onnettomuuksien yleisiin ehkäisytapoihin. Turvallisuusvaroitusten käännökset löytyvät laitteen mukana toimitettujen käännettyjen turvallisuusvaroitusten joukosta varoitusten lopussa näkyvien lausuntonumeroiden avulla.
SÄILYTÄ NÄMÄ OHJEET
Attention IMPORTANTES INFORMATIONS DE SÉCURITÉ
Ce symbole d'avertissement indique un danger. Vous vous trouvez dans une situation pouvant entraîner des blessures ou des dommages corporels. Avant de travailler sur un équipement, soyez conscient des dangers liés aux circuits électriques et familiarisez-vous avec les procédures couramment utilisées pour éviter les accidents. Pour prendre connaissance des traductions des avertissements figurant dans les consignes de sécurité traduites qui accompagnent cet appareil, référez-vous au numéro de l'instruction situé à la fin de chaque avertissement.
CONSERVEZ CES INFORMATIONS
Cisco uBR10012 Universal Broadband Router Fan Assembly Module
|
OL-5093-01 |
5 |
|
|
|
Warnung WICHTIGE SICHERHEITSHINWEISE
Dieses Warnsymbol bedeutet Gefahr. Sie befinden sich in einer Situation, die zu Verletzungen führen kann. Machen Sie sich vor der Arbeit mit Geräten mit den Gefahren elektrischer Schaltungen und den üblichen Verfahren zur Vorbeugung vor Unfällen vertraut. Suchen Sie mit der am Ende jeder Warnung angegebenen Anweisungsnummer nach der jeweiligen Übersetzung in den übersetzten Sicherheitshinweisen, die zusammen mit diesem Gerät ausgeliefert wurden.
BEWAHREN SIE DIESE HINWEISE GUT AUF.
Avvertenza IMPORTANTI ISTRUZIONI SULLA SICUREZZA
Questo simbolo di avvertenza indica un pericolo. La situazione potrebbe causare infortuni alle persone. Prima di intervenire su qualsiasi apparecchiatura, occorre essere al corrente dei pericoli relativi ai circuiti elettrici e conoscere le procedure standard per la prevenzione di incidenti. Utilizzare il numero di istruzione presente alla fine di ciascuna avvertenza per individuare le traduzioni delle avvertenze riportate in questo documento.
CONSERVARE QUESTE ISTRUZIONI
Advarsel VIKTIGE SIKKERHETSINSTRUKSJONER
Dette advarselssymbolet betyr fare. Du er i en situasjon som kan føre til skade på person. Før du begynner å arbeide med noe av utstyret, må du være oppmerksom på farene forbundet med elektriske kretser, og kjenne til standardprosedyrer for å forhindre ulykker. Bruk nummeret i slutten av hver advarsel for å finne oversettelsen i de oversatte sikkerhetsadvarslene som fulgte med denne enheten.
TA VARE PÅ DISSE INSTRUKSJONENE
Aviso INSTRUÇÕES IMPORTANTES DE SEGURANÇA
Este símbolo de aviso significa perigo. Você está em uma situação que poderá ser causadora de lesões corporais. Antes de iniciar a utilização de qualquer equipamento, tenha conhecimento dos perigos envolvidos no manuseio de circuitos elétricos e familiarize-se com as práticas habituais de prevenção de acidentes. Utilize o número da instrução fornecido ao final de cada aviso para localizar sua tradução nos avisos de segurança traduzidos que acompanham este dispositivo.
GUARDE ESTAS INSTRUÇÕES
¡Advertencia! INSTRUCCIONES IMPORTANTES DE SEGURIDAD
Este símbolo de aviso indica peligro. Existe riesgo para su integridad física. Antes de manipular cualquier equipo, considere los riesgos de la corriente eléctrica y familiarícese con los procedimientos estándar de prevención de accidentes. Al final de cada advertencia encontrará el número que le ayudará a encontrar el texto traducido en el apartado de traducciones que acompaña a este dispositivo.
GUARDE ESTAS INSTRUCCIONES
Cisco uBR10012 Universal Broadband Router Fan Assembly Module
6 |
OL-5093-01 |
|
|