Cisco Systems STEV SRT-M-66 User Manual
Size:
853.38 Kb
Download

Appendix A Repackaging the Router

Repackaging the Routers

REVIEW DRAFT —CISCOCONFIDENTIAL

Completing the Repackaging

To repackage the router, use Figure A-1 on page A-4 as a reference and follow these steps:

Step 1 Verify that the anchor clips fastening the chassis to thescissor-jackplatform are installed correctly and that the bolts are tight.

Step 2 Verify that the bolts fastening thehold-downbrackets to the sides of thescissor-jackplatform and the top of the pallet are tight.

Step 3 Pull the plastic bag over the router to protect it against electrostatic discharge (ESD) and dust.

Step 4 Place the side of the accessories package with the single box containing thecenter-mountrack-mountingbrackets against the back panel of the router on the extended deck of the pallet body.

Step 5 Place the folded corrugated spacer on top of the accessories package, then place the two foam inserts around the top of the router.

Step 6 To install theU-shaped,corrugated side panels, useFigure A-1 on page A-4 as a reference and follow these steps:

a.Set the long side of one panel on the pallet base such that it sits inside the bead-boardsattached to the outside corners of the pallet riser blocks and against the side of the pallet platform.

b.Set the narrow end flaps of the panel inside the bead-boardsattached to the outside corners of the pallet riser blocks.

c.Position the opposite U-shapedside panel such that one narrow end flap is inside the narrow end flap of the firstU-shapedside panel, while the other narrow end flap is outside the narrow end flap of the firstU-shapedside panel.

Note Because the twoU-shapedside panels are identical, interlocking them in this fashion maintains the correct overall container dimensions and strength.

 

 

Cisco XR 12416 Router Chassis Installation Guide

 

 

 

 

 

 

OL-xxxxx-xx

 

 

A-23