®
3-BUTTON REMOTE CONTROLS MODELS 953EV, 953EVC, 956EV AND 956EVC
For use with Chamberlain 315 MHz or 390 MHz garage door openers manufactured after January 1, 1993. The garage door opener activates when the programmed button on the remote control is pressed. The remote control can activate up to three garage door openers.
Make sure the garage door opener has a working light bulb because it is a programming indicator.
GARAGE ACCESS SYSTEM |
GARAGE ACCESS SYSTEM |
REMOTE |
KEYCHAIN REMOTE |
MODELS 953EV AND 953EVC |
MODELS 956EV AND 956EVC |
LED |
LED |
|
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with remote controls.
•Activate gate or door ONLY when it can be seen clearly, is properly adjusted and there are no obstructions to door travel.
•ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
PREPARE
Learn
LED
Green or
Red/Orange
|
Locate the Learn |
||
|
button on the garage |
||
|
door opener. |
||
|
NOTE: Your garage door |
||
|
opener may look different. |
||
OR |
|
|
OR |
|
|
|
Learn |
|
|
|
LED |
Learn |
|
|
|
LED |
|
|
|
Purple |
|
|
Yellow |
|
|
||
|
|
||
|
|
|
Locate the Program button on the remote control.
953EV & |
Program Button |
953EVC |
|
956EV &
956EVC
Program Button
PROGRAM THE REMOTE CONTROL (953EV & 953EVC)
1
To enter
programming
mode, use the
visor clip to
press the Program
button until the LED
on the front of the remote control turns on.
2 Press and release the Learn button on the garage door opener.
The Learn LED will light.
Within 30 seconds...
3Press and release the remote control button you want to use...
Check to see if the garage door opener light bulb blinks. If not, wait for the remote control LED to light solid then slowly press and release the remote control button again. Repeat until the light bulb blinks.
DO NOT press the button after the light bulb blinks.
4To exit programming mode, press any remote control button except
the button that was just programmed.
5 |
To test, press the programmed button on |
6 |
Install the visor clip. |
|
the remote control... |
|
|
The garage door opener will activate.