®
WIRELESS KEYLESS ENTRY • MODELS 940EV AND 940EVC
For use with Chamberlain 315 MHz or 390 MHz garage door openers manufactured after January 1, 1993. The garage door opener activates when the 4-digit Personal Identification Number (PIN) and ENTER button are pressed on the Keyless Entry.
Install the battery and program the Keyless Entry prior to installation. Make sure the garage door opener has a working light bulb because it is a programming indicator.
To prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:
•Install Keyless Entry Control within sight of the garage door, out of reach of children at a minimum height of 5 feet (1.5 m), and away from ALL moving parts of door.
•ALWAYS keep remote controls out of reach of children. NEVER permit children to operate, or play with remote controls.
•Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to door travel.
•ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone to cross path of moving gate or door.
PREPARE |
PROGRAM INITIAL PIN |
3 |
Enter a 4-digit |
|
personal |
|
identification |
number (PIN) of your choice:
? ? ? ?
Locate the Learn button on the garage door opener.
NOTE: Your garage door opener may look different.
Learn |
|
|
Learn |
|
LED |
|
|
||
|
|
LED |
||
|
|
OR Learn |
|
OR |
Green |
|
LED |
|
|
or |
|
Purple |
|
Yellow |
Red/Orange |
|
|||
|
|
4 Press and release the ENTER
button... Check to see if the
light bulb blinks.
If not, slowly
press and release
the ENTER button
until the light bulb
blinks. Be careful NOT to
press the ENTER button after the light bulb blinks.
1
5
2
Press and hold
the * and # |
|
|
buttons until |
|
|
the lights on the |
||
keypad stop |
|
Press and |
|
release the |
|
blinking. |
|
|
|
Learn button. |
|
|
|
|
|
|
The LED will light. |
|
|
Within 30 seconds... |
|
|
|
Press 0 to |
6 |
To test, press the PIN, then press the ENTER button. |
complete the |
|
|
programming. |
|
|
? ? ? ? +
PIN
The garage door opener will activate.
To program the Keyless Entry to more than one garage door opener, repeat the steps above using a new PIN for each additional garage door opener.
CHANGE AN EXISTING PIN*
1Press the programmed PIN that you want to change.
? ? ? ?
2 Press and hold the
# button until...
...the light bulb blinks twice.
3 Enter the new 4-digit PIN of your choice, then press the ENTER button.
? ? ? ? + new PIN
The light bulb will blink once.
4To test, press the new PIN, then the ENTER button. The garage door opener will activate.
* For garage door openers that have a green Learn button or an external receiver repeat "Program Initial PIN" to change the existing PIN.