Cannon 10545G, 10540G, 10548G User Manual

4 (1)

CHESTER

Use and Installation Instructions

The cooker must be installed in accordance with the regulations in force and only used in a well ventilated space.

Read these instructions prior to using the cooker and retain them for future reference.

Part no. 195040612.04

 

CONTENTS

 

 

PAGE

 

 

INTRODUCTION

3

FOR YOUR SAFETY

4

AUTOMATIC COOKING

6

TIMER OPERATION

7

HOTPLATE

13

TOP OVEN

15

TOP OVEN COOKING CHART

16

GRILL

18

MAIN OVEN

20

MAIN OVEN COOKING CHART

22

THE 'SLOW COOK' SETTING

24

CARE AND CLEANING

25

SOMETHING WRONG WITH YOUR COOKER

27

INSTALLATION INSTRUCTIONS

29

SERVICE INFORMATION

Back Cover

2

INTRODUCTION

To help you make the best use of your cooker, PLEASE READ THIS BOOKLET CAREFULLY.

Your new cooker is guaranteed and will give lasting service. The guarantee is only applicable if the cooker has been installed in accordance with the Installation Instructions.

The cooker is designed specifically for domestic use and responsibility will not be accepted for use in any other installation.

When first using the cooker ensure that the room is well ventilated (e.g. open a window or use an extractor fan) and that persons who may be sensitive to the odour avoid any fumes. It is suggested that any pets be removed from the room until the smell has ceased. This odour is due to any temporary finish and also any moisture absorbed by the insulation.

Our policy is one of continual improvement in design and development, therefore strict accuracy of illustrations and descriptions cannot be guaranteed.

This appliance conforms to the following EEC Directive:

Gas Appliances 90/396/EEC

Low Voltage Equipment 73/23/EEC

93/68/EEC

Electromagnetic Compatibility 89/336/EEC

92/31/EEC

93/68/EEC

3

 

 

FOR YOUR SAFETY

 

 

 

 

Please read the precautions below before using your cooker.

ALWAYS

make sure you understand the controls before using the cooker.

ALWAYS

check that all controls on the cooker are turned off after use.

ALWAYS

stand back when opening an oven door to allow heat to disperse.

ALWAYS

use dry, good quality oven gloves when removing items from the ovens.

ALWAYS

take care when removing items from the top oven/grill when the main

 

oven is on, as the contents may be hot.

ALWAYS

keep the oven and grill doors closed when the cooker is not in use.

ALWAYS

place pans centrally over the hotplate burners and position them so that

 

the handles cannot accidentally be caught or knocked or become heated

 

by other burners.

ALWAYS

keep the cooker clean, as a build up of grease or fat from cooking can cause

 

a fire.

ALWAYS

allow the cooker to cool before cleaning.

ALWAYS

follow the basic principles of food handling and hygiene to prevent the

 

possibility of bacterial growth.

ALWAYS

keep ventilation slots clear of obstructions.

ALWAYS

turn off the electricity supply before cleaning or replacing the oven lamp.

ALWAYS

refer servicing to CORGI registered appliance service engineers.

4

 

 

FOR YOUR SAFETY

 

 

 

 

NEVER

leave children unsupervised where the cooker is installed as all surfaces

 

will get hot during and after use.

NEVER

allow anyone to sit or stand on any part of the cooker.

NEVER

store items that children may attempt to reach above the cooker.

NEVER

heat up unopened food containers as pressure can build up causing the

 

container to burst.

NEVER

store chemicals, food stuffs, pressurised containers in or on the cooker, or in

 

cabinet immediately above or next to the cooker.

NEVER

fill a deep fat frying pan more than 1/3 full of oil, and never use a lid. DO NOT

 

LEAVE UNATTENDED WHILE COOKING.

NEVER

place flammable or plastic items on or near the hotplate.

NEVER

use proprietary spillage collectors on the hotplate.

NEVER

use the cooker as a room heater.

NEVER

dry clothes or place other items over or near to the hotplate or oven/grill

 

doors.

NEVER

wear garments with long flowing sleeves whilst cooking.

NOTE: The use of a gas cooking appliance results in the production of heat and moisture in the room in which it is installed. Always ensure that the kitchen is well ventilated; keep natural ventilation holes open or install a mechanical ventilation device (mechanical extractor hood).

In particular when using the grill or more than one hotplate burner, open a window if a mechanical ventilation device is not operating.

5

AUTOMATIC COOKING

AUTOMATIC COOKING

Only the main oven can be controlled automatically.

GUIDANCE ON AUTOMATIC COOKING

1.When planning your meal remember that the oven control setting refers to the temperature on the middle shelf; above this shelf it is hotter and below it is cooler. Therefore foods which require different temperatures can be cooked automatically at the same time.

2.Set the oven timer so that the food has just finished or about to finish cooking on your return to the oven. This will ensure the food has not cooled down and does not require reheating before serving.

3.Food should be as cold as possible when it goes into the oven ideally straight from the refrigerator. Frozen meat and poultry should be thawed thoroughly before it is put in the oven.

4.We advise that warm food should never be placed in the oven if there is to be a delay period. Stews prepared by frying the meat and vegetables should be cooked as soon as possible.

5.We advise dishes containing left-over cooked poultry or meat, for example Shepherds Pie, should not be cooked automatically if there is to be a delay period.

6.Stews and joints should be cooked by the long slow method, so that the delay period is kept to a minimum.

7.On warm days, to prevent harmful bacterial growth in certain foods (ie poultry, joints, etc) the delayed start should be kept to a minimum.

8.Wine or beer may ferment and cream may curdle during the delay period, so it is best to add these ingredients just before serving.

9.Foods which discolour should be protected by coating in fat or tossing in water to which lemon juice has been added, prior to placing food in the oven.

10.Dishes containing liquid should not be filled too full to prevent boiling over.

11.Foods should be well sealed (but not airtight) in a container to prevent the loss of liquid during cooking. Aluminium foil gives a good seal.

12.Ensure food is cooked thoroughly before serving.

6

TIMER OPERATION

CLOCKFACE

The timer incorporates a 24 hour clock.

Ensure the correct time of day is always set, before using you cooker.

SYMBOLS

Will light up when you select a Minute Minder Period and will remain lit for the period set.

This “Cookpot” symbol will light up either:– _ When the cooker is in "Manual Mode"

– When you press the Cook Period Button and set a length of time for an Auto Cooking Programme. ( symbol will light up during Auto Cooking)

"A" will light up:–

When the timer is first turned on it will flash. (It will go out when a time of day is set.

When an Auto Cooking Programme has been set.

The Auto symbol "A" will flash at the end of an Auto Cooking programme to indicate that the programme has finished.

(When the "A " symbol is flashing, to return the oven to Manual operation, turn the oven controls off, ensure that the correct time of day is set, and press the "Cook Period & End Time" buttons together– The "A" symbol will go out.)

TIMER FUNCTION BUTTONS

Minute Minder Button Here you can set a time period of up to 23 hours 59 minutes, that will count down. When it reaches zero, the timer will emit an audible tone.

For Example: If you set 20 minutes, the audible tone will occur 20 minutes later.

AUTO COOKING PROGRAMME

Cook Period Button

Cook Period is the actual length of time for which, the timer will switch the oven(s)

 

on as part of an "Auto Cooking" programme.

 

(e.g. If you set 2 hours, the food will be cooked for 2 hours).

End Time Button

The time of day at which you want an “Auto Cooking” programme to end.

 

For Example: If you set a "Cook Period" for 2 hours, and "End Time" of 11:00. The

 

timer will switch the oven(s) on at 9:00 and turn the oven(s) off at 11:00. You will

 

hear a audible tone at 11:00, to indicate that the Auto Cooking Programme has

 

finished.

Notes:

When setting an Auto Cooking programme you will need to set the oven controls(s) to the required temperature(s) when you set the timer.

If an Auto Cooking programme has been set the oven(s) will only operate during the pre-programmed time.

"+" and "–" Buttons

Used to adjust the various timer function settings.

7

Cannon 10545G, 10540G, 10548G User Manual

TIMER OPERATION

SETTING THE TIME OF DAY

Step 1 Make sure all oven controls are turned Off.

Step 2 Check the electricity supply to the cooker is turned on.

When switched on the display will show 0.00 and "A" symbol, both will be flashing intermittently.

Step 3 Press & hold in both the "Cook Period & End Time" buttons together.

Step 4 With the "Cook Period & End Time" buttons still held in,

press either the "+" or "–" buttons to set the correct time of day.

Step 5 Release all the buttons simultaneously.

The time of day is now set and the symbol will light up to show that the timer is in "Manual Mode"

To change the time of day repeat Steps 3, 4 & 5 above.

Note: You cannot adjust the time of day if the timer has been set for an Auto Cooking Programme.

SETTING THE MINUTE MINDER

Step 1 Ensure the time of day is set correctly.

Step 2 Press and hold the Minute Minder Button.

Step 3 With the "Minute Minder" button held in, set the required Minute

Minder time using the "+" and "–" buttons, a symbol will light up.

Release all buttons and the timer display will revert back to the time of day. Bell symbol will remain lit to signify that a Minute Minder period has been set.

At the end of the set time a bleeping sound will be heard, and the symbol will go out.

The bleeping sound will continue for several minutes unless cancelled (see step 4)

Step 4

To cancel the bleeping sound press the Minute Minder button, timer

 

display will revert back to the time of day after the buttons are

 

released.

 

To cancel Minute Minder before the Minute Minder period has finished.

Step 1

Press the minute minder button.

 

Step 2

Press the "_" button until 0.00 and the

symbol appear in the

Step 3

display window.

 

To cancel the bleeping sound press Minute Minder button.

Note 1

When the Minute Minder has been set, the time remaining can be checked

 

at any time by simply pressing the Minute Minder button

 

 

8

TIMER OPERATION

There are two Auto Cooking programmes that can be selected using your timer:-

a)To set the timer to switch the oven(s) On and Off automatically.

b)To set the timer to switch On immediately and OFF automatically after a set cook period.

a)TO SET TIMER TO SWITCH THE OVEN(S) ON AND OFF AUTOMATICALLY.

Step 1 Check that the correct time of day is set, if not follow instructions for setting the time of day.

Step 2 Place food onto the correct shelf position in the oven and close the oven door(s).

Step 3 Press & hold in the “Cook Period” button, the display will read 0.00 with the cookpot symbol lit up.

Step 4 With the Cook Period button still held set the required Cook Period using the “+” and “–” buttons.

Release the buttons and the timer display will revert to the time of day with the Auto symbol "A" & Cookpot symbol remaining lit.

Step 5 Press and hold the" End Time" button.

The display will read the earliest possible end time for the cook period that you have set above.

Step 6 With the End Time button still held in, use the "+" and "-" buttons to set the "End Time". i.e. The time you require the oven to switch off.

Release all the buttons and the timer will revert back to the time of day.

The "A" symbol will remain lit to signify that an Auto Cooking Programme has been set. The symbol will go out. When the Auto Cook Programme starts the

will then light up again.

Step 7 Turn the oven control(s) to the required temperature, and if necessary select the appropriate oven.

9

TIMER OPERATION

At the end of the Automatic Cook Period the Auto Symbol "A" will flash and an intermittent bleeping sound will be heard. The symbol will go out.

The bleeping sound will continue for several minutes unless

cancelled. (see step 8) The "A" symbol will continue to flash until the timer is returned to Manual operation (see below).

Step 8

Press the Cook Period button to cancel the bleeping sound.

Step 9

Turn the oven control(s) to the OFF position.

Step 10

Press the Cook Period and End Time buttons together to return the oven(s) to Manual Operation. The "A" symbol will go out and the Cookpot symbol will light up

Note 1 When cooking automatically the Cook Period can be checked at any time by simply pressing the Cook Period button.

Note 2 When cooking automatically the End Time can be checked at any time by simply pressing the End Time button.

10

TIMER OPERATION

b) TO SET TIMER TO SWITCH ON IMMEDIATELY AND OFF AUTOMATICALLY AFTER A SET COOK PERIOD

Step 1Check that the correct time of day is set, if not follow instructions for setting the time of day.

Step 2Place food onto the correct shelf position in the oven and close the oven door(s).

Step 3Turn the oven control(s) to the required temperature, and if necessary select the appropriate oven function.

Step 4 Press & hold in the "Cook Period" button, the display will read 0.00 and the cookpot symbol will light up.

With the Cook Period button still held set the required Cook Period using the "+" and "–" buttons, the "A" symbol will light up. Example: 1hr 30 minutes).

Note: Cook Period is the length of time the food requires to cook.

Step 5 Release all buttons.

The timer display will revert to the time of day with the Auto symbol "A" lit &

Cookpot symbol remaining lit.

At the end of the Cook Period the"A" symbol will flash and an intermittent bleeping sound will be heard. The cookpot symbol will go out.

The bleeping sound will continue for several minutes unless cancelled. (see step 6) The "A" symbol will continue to flash until the timer is returned to Manual operation (see below).

Step 6 Press the "Cook Period" button to cancel the bleeping.

Step 7

Turn the oven control(s) to the OFF position.

Step 8

Press the "Cook Period" and "End Time" buttons together to return

 

the cooker to Manual operation. (The "A" symbol will go out, and the

 

Cookpot symbol will light up).

Note 1 When cooking automatically the Cook Period can be checked at any time by simply pressing the Cook Period button.

Note 2 When cooking automatically the End Time can be checked at any time by simply pressing the End Time button.

11

Loading...
+ 25 hidden pages