Cabletron Systems 9F426-03 User Manual
Size:
211.27 Kb
Download

SmartSwitch 9000

9F426-03

Local Management Appendix

9032058-01

Appendix

9F426-03Module Specific

Information

Introduction

This appendix contains local management information that is specific to the 9F426-03FDDI Switch Module.

Module Interfaces

The 9F426-03FDDI Switch Module has 8 interfaces.Table 1 lists the identifying number, name, and description of each interface.

Table 1. 9F426-03FDDI Switch Module Interfaces

Interface

Interface

Interface

Number

Name

Description

 

 

 

 

 

 

1

SMB1

1 Mbps System Management Bus

 

 

 

2

SMB10

10 Mbps System Management Bus

 

 

 

3

HOST

i960 Host

 

 

 

4

CONTROL

i960 Data Controller

 

 

 

5

INB

Internal Network Bus

 

 

 

6

FRONT1

FDDI Front Panel Port 1

 

 

 

7

FRONT2

FDDI Front Panel Port 2

 

 

 

8

FRONT3

FDDI Front Panel Port 3

 

 

 

1

9F426-03Module Specific Information

Use the numbers listed in Table 1 to configure the module’s default interface (see General Configuration Screen in theSmartSwitch 9000 Module Local Management User’s Guide).

2

9F426-03Module Specific Information

Ring Map Configuration Screen

The Ring Map Configuration Screen (Figure 1), contains configuration and connection information and displays the topology of the FDDI rings connected to the module.

 

SmartSwitch 9000 Local Management

 

 

Ring Map Configuration

 

Module Name:

9F426-03

Firmware Revision: 01.04.10

Slot Number:

11

BOOTPROM Revision: 01.02.00

FDDI Address: 00:00:B8:00:10:62

MAC Count: 1

 

Current RingMap: FRONT PANEL 1 (isolated)

Address Mode: [MAC]

 

00:00:B8:00:10:62 (NAS) <<<<<<<<<<<<<<<<<<<

SMT-Unknown-Address

[FRONT PANEL 1

(isolated)]

EXIT

RETURN

 

 

 

 

Figure 1. Ring Map Configuration Screen

3

9F426-03Module Specific Information

Ring Map Configuration Screen Fields

The following information briefly explains each Ring Map Configuration Screen field.

FDDI Address

Displays the address of the module. The format of this address (either MAC or Canonical) is determined by the value you select in the Address Mode field.

MAC Count

Displays the number of MACs (Media Access Controllers) that are attached to the specified ring.

Current Ring Map

Identifies the ring on which a MAC for the specified module resides, and whether that MAC is located on the primary or secondary path of that ring.

Address Mode (Toggle)

Allows you to select the format in which addresses appear on this screen. Press the Space Bar to toggle to the desired value. The Address Mode possibilities are:

MAC

Canonical

FRONT PANEL x (Toggle)

Allows you to display information about the module’s front panel ports.

Choosing a Front Panel Port

To choose a front panel port:

1.Use the arrow keys to highlight the FRONT PANEL x field (lower left corner of screen).

2.Press the Space Bar to toggle to the desired port.

3.Press the Return key.

4