Cabletron Systems 6A000-ZX-250 User Manual
Size:
1.27 Mb
Download

Introduction

Descriptions

Table 1-4Description Table Explanation

Operator

Parameters/Permissions

Description

 

 

 

console

command

[InputParameter] <whatyoutype> This section provides detailed descriptions of the command

(Privilege level this console command

(operator and switch attribute) and discusses what the

allows:)

command does and how and when it is used. Other relevant

Administrator or All

information appears here.

The following is an example of a description section. It is located under "BUSELAN." Note the detailed description of the command following the table.

Table 1-5Description Table Example

Operator

Permissions/Parameters

Description

 

 

 

modify buselan

[ELANNumber] <elannumber>

Changes the behavior of the BUS parameters for a

 

[ELANName] <elanname>

specified ELAN. The specified ELAN is then

 

[ConnectMethod] <connectmethod>

deleted and recreated. If the corresponding

 

[ELANType] <elantype>

LESELAN exists, then the modified BUSELAN

 

[Multipoint] <distributevcctpe>

should have the same characteristics as that

 

[MTU] <maximumframesize>

existing LESELAN because their parameters need

 

Administrator

to match.

Examples

Examples are copied exactly from the switch console to show you what you should see. They appear at the end of each section in the same order as the operators are listed at the start of each section. There is no significance to the order in which the examples appear, except that show usually appears after the other command examples to demonstrate how a command can change a characteristic of the switch. Unless they fit on the current page, examples usually begin at the top of a page. The location of every command example appears in the index under "Examples".

Examples show how you must enter console commands at the switch prompt (indicated in bold - modify buselan (console command)). The other bold text (1, 103, pvc, 802.5, 4544) is the input parameters that modify this switch attribute (BUSELAN). The text in brackets (immediately following the parameter field - for example, ELANType(802.3)) indicates the current default. See the following examples.

switch_prompt # modify buselan(console command)

ELANNumber(0)

:103(input entry)

ELANName(ELAN102)

:elan103(input entry)

ConnectMethod(SVC)

:pvc(input entry)

ELANType(802.3)

:802.5(input entry)

Multipoint(YES)

: (accept default)

MTU(1516)

:4544 (input entry)

switch_prompt #

 

1-8SmartCell6A000/ZX-250Reference Manual