Bushnell 111026 User Manual

0 (0)

Model #: 111026

Lit. #: 98-0828/07-10

Instruction

Manual

Version 2.0

WARNING

Do NOT look directly at the sun through your binoculars.

Doing so may cause permanent eye damage.

NOTE: To reset the camera if you experience problems or if the display becomes unresponsive, remove the batteries for at least one minute, then re-install them.

3

Congratulations on your purchase of the Bushnell ImageView® binocular! The Bushnell ImageView binocular takes the technology of digital photography and combines it with a high-quality compact binocular. This allows you to observe sporting events, wildlife, scenic vistas or anything you would normally use a binocular for, and then save the image in a built-in attached digital camera. You can then download these images to your computer and e-mail them to your friends and family, print out the pictures, or save them in a photo album for future use. Before using the product, please read the instructions contained in this manual and take time to familiarize yourself with the different parts and features of the product.

4

Bushnell 111026 User Manual

Camera and Binocular Parts Guide

Binocular

Focus

Power/

MODE

Button

SNAP

Button

Camera

Lens

USB

Port

Remote

SD Card Slot

Jack

 

Tripod

Socket

Battery

Compartment

5

SetupCAMERA PARTSand Basic Operation

1.The camera is powered by two AAA alkaline, lithium, or NiMh batteries (not included). Insert batteries into the compartment, with the springs in contact with the negative (flat) end of each battery. A power meter on the left center of the display indicates battery condition.

2.Insert an SD card ("upside down" with metal contacts facing up) in the slot if greater storage is desired. You may use SD cards (not MMC cards) up to 8 GB capacity.

3.Press and hold the MODE button until the camera turns on. The camera will turn off automatically after about one minute if no buttons are pressed. Note: when the camera is connected to a computer via the supplied USB cable, the camera will power on automatically, and draw power from the computer with no battery drain.

4.Hold the ImageView steady and press SNAP to take a picture (or start/stop shooting a video, when the camera is in video mode). The camera focus is preset to take sharp photos from appoximately 35 feet to infinity.

5.When using a tripod, you can help avoid the effects of camera shake by plugging the supplied remote shutter release into the jack next to the SD card slot, and using the button on the remote rather than SNAP to take photos.

6

Loading...
+ 14 hidden pages