Bushnell 11-9303 User Manual

3.38 Mb

Setup Guide (cont.)

Batteries typically last 30 days or more, depending on how often the Sentry is activated by events, how often the flash fires, ambient temperature, etc. The red LED lamp will stay on continually to indicate a low battery condition.

9. Pressing the Up/Down buttons during normal operation will switch the display between showing # of photos stored (i) and # of events recorded (j). To view your captured photos, make sure the power is off, and remove the SD card by pushing down lightly on the top edge of thecard-itwill pop up for removal. Insert it into an SD card reader (available at most computer, photo, or electronics dealers) connected via USB to your PC or Mac to view, copy, or delete the photos (standard JPG files) and movies (AVI files) inside the “DCIM/100MEDIA” folder on the card. Double click on an individual file to see it, or open the files using the photo software of your choice. The event log is the .TXT file, just double click to view with your default software that opens standard plain text files. If you do not have a computer, or would like to more easily view your photos in the field, we recommend the Bushnell Trail Scout

Viewer. It is battery powered, and features 2 SD card slots, allowing you to easily

copy photos to a larger capacity card, or delete unwanted photos, as well as view


your Sentry photos on its large color LCD display. The Trail Scout Viewer also has


a USB port, so it can function as a card reader for a computer as well.




119303 Trail Sentry manual-Engli1111



2/13/07 12:19:07 AM








The sensor that triggers the trail camera is Passive Infra Red, or PIR. Infrared energy is essentially heat energy. The PIR detector operates by sensing a change in the infrared level in its detection zone. This zone is a cone in the center 10 degrees of the camera’s field of view. The camera establishes an average long-terminfrared level. When this level increased suddenly the PIR detector signals the camera to record a picture and/or an event. Because of this effect, the PIR detector will be more sensitive at night, when the average temperature is lower.

You can use the red LED indicator on the front of the camera to confirm the detection zone. When PIR is sensed, this “PIR detected” indicator will light. The camera’s field of view is a

45 degree cone, centered on the PIR detection zone.


119303 Trail Sentry manual-Engli1212



2/13/07 12:19:07 AM








119833—DigitalTrail Scout 3.0MP

Great images and scouting technology at a great value. This camera will sense deer and other game as far out as 90 feet with its passive infrared sensor. Low-batteryindicator lights when battery life drops below 25%. Motion LED lights when activity is detected by the sensor in regular imaging mode and during setup mode for aiming. Weatherproof. Date/Time/Moon Phase stamp feature. Comes complete with aircraft aluminum security cable, padlock, and tree bracket. Textured“bark-like”surface for maximum concealment.

119935/119905 (RealTree AP® Camo)—DigitalTrail Scout 5.0MP with Night Vision

With all the features of the 3.0MP Trail Scout plus Night Vision and laser aiming , this is the top of the line digital trail camera. Still photos are stored with 5 megapixel resolution (via software processing), and the video clips are recorded with audio captured by a built-inmicrophone. Choose your setting for regular camera flash orstealth-likeLED flash. LED flash enables you to discretely image game in the night without a visible flash. There is no need to worry about your flash giving away your position in popular, busy hunting areas. And no need to manually set an infrared filter switch for day or night mode to get greatresults-it’sdone for you automatically. This camera comes complete with a laser aiming beam for easy set up in the woods.


119303 Trail Sentry manual-Engli1313



2/13/07 12:19:07 AM








Your Bushnell® product is warranted to be free of defects in materials and workmanship for two years after the date of purchase. In the event of a defect under this warranty, we will, at our option, repair or replace the product, provided that you return the product postage prepaid. This warranty does not cover damages caused by misuse, improper handling, installation, or maintenance provided by someone other than a Bushnell Authorized Service Department.

Any return made under this warranty must be accompanied by the items listed below:

1)A check/money order in the amount of $10.00 to cover the cost of postage and handling

2)Name and address for product return

3)An explanation of the defect

4)Proof of Date Purchased

5)Product should be well packed in a sturdy outside shipping carton, to prevent damage in transit, with return postage prepaid to the address listed below:

IN U.S.A. Send To:


Bushnell Outdoor Products

Bushnell Performance Optics

Attn.: Repairs

Attn.: Repairs

8500 Marshall Drive

5A East Pearce Street, Unit 1

Lenexa, Kansas 66214

Richmond Hill, Ontario L4B 2M9

For products purchased outside the United States or Canada please contact your local dealer for applicable warranty information. In Europe you may also contact Bushnell at:

BUSHNELL Performance Optics Gmbh European Service Centre MORSESTRASSE 4


Tél: +49 (0) 221 709 939 3

Fax: +49 (0) 221 709 939 8

This warranty gives you specific legal rights.

You may have other rights which vary from country to country. ©2007 Bushnell Outdoor Products

FCC Note:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

·Reorient or relocate the receiving antenna.

·Increase the separation between the equipment and receiver.

·Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

·Consult the dealer or an experienced radio/TV technician for help.

Shielded interface cable must be used with the equipment in order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.

Specifications and designs are subject to change without any notice or obligation on the part of the manufacturer.

119303 Trail Sentry manual-Engli1414



2/13/07 12:19:08 AM
























































































119303 Trail Sentry manual-Engli1515












2/13/07 12:19:08 AM








































For further questions or additional information please contact:

Bushnell Outdoor Products

9200 Cody, Overland Park, Kansas 66214

(800) 423-3537• www.bushnell.com

©2007 Bushnell Outdoor Products

119303 Trail Sentry manual-Engli1616



2/13/07 12:19:08 AM