- •225 Series
- •OPERATOR’S MANUAL
- •BUSH HOG®
- •To the Owner/Operator/Dealer
- •REAR MOUNTED BLADE
- •TABLE OF CONTENTS
- •Safety Messages
- •SAFETY SECTION
- •Decal Description
- •Federal Laws and Regulations
- •INTRODUCTION SECTION
- •ASSEMBLY SECTION
- •Assembly of Moldboard to Mainframe
- •Skid Shoes & Quick Tack End Plates (Extra Equipment)
- •Hydraulic System
- •Selector Valve (Accessory Equipment)
- •2. OPERATOR REQUIREMENTS
- •3.1 ROPS and Seat Belt
- •3.2 Tractor Horsepower
- •3.3 Tractor 3-Point Hitch
- •3.4 Front End Weight
- •4. GETTING ON AND OFF THE TRACTOR
- •4.1 Boarding the Tractor
- •4.2 Dismounting the Tractor
- •5. STARTING THE TRACTOR
- •6. CONNECTING THE REAR BLADE TO THE TRACTOR
- •6.1 Connecting the Rear Blade
- •1. Shorten or remove the tractor drawbar to avoid interference when raising and lowering the rear blade..
- •3. Turn off the tractor engine, set the parking brake, place the tractor in park, and dismount.
- •6. Adjust any lower link check chains, guide blocks, or sway blocks to prevent the blade from swaying side to side and possible contact with tractor rear tires.
- •7. PRE-OPERATION INSPECTION AND SERVICE
- •7.1 Tractor Pre-Operation Inspection/Service
- •7.2 Blade Pre-Operation Inspection/Service
- •8. DRIVING THE TRACTOR AND IMPLEMENT
- •8.1 Starting the Tractor
- •8.2 Brake and Differential Lock Setting
- •8.3 Driving the Tractor and Blade
- •9. OPERATING THE TRACTOR AND IMPLEMENT
- •Ditching (V-Type Ditch)
- •9.2 Shutting Down the Implement
- •10. DISCONNECTING THE BLADE FROM THE TRACTOR
- •11. BLADE STORAGE
- •12. TRANSPORTING THE TRACTOR AND IMPLEMENT
- •12.1 Transporting on Public Roadways
- •12.2 Hauling the Tractor and Implement
- •Install Skid Shoes.
- •or types.
- •OPERATION SECTION
- •MAINTENANCE SECTION
- •Proper Torque For Fasteners
- •225 Series
- •Rear Mounted Blade
- •LIMITED WARRANTY
- •DISCLAIMER OF IMPLIED WARRANTIES & CONSEQUENTIAL DAMAGES
- •THIS LIMITED WARRANTY SHALL NOT APPLY:
- •1. To vendor items which carry their own warranties, such as engines, tires, and tubes.
- •2. If the unit has been subjected to misapplication, abuse, misuse, negligence, fire or other accident.
- •3. If parts not made or supplied by Bush Hog have been used in connection with the unit, if, in the sole judgement of Bush Hog such use affects its performance, stability or reliability.
- •4. If the unit has been altered or repaired outside of an authorized Bush Hog dealership in a manner which, in the sole judgement of Bush Hog, affects its performance, stability or reliability.
- •5. To normal maintenance service and normal replacement items such as gearbox lubricant, hydraulic fluid, worn blades, or to normal deterioration of such things as belts and exterior finish due to use or exposure.
- •6. To expendable or wear items such as teeth, chains, sprockets, belts, springs and any other items that in the company’s sole judgement is a wear item.
- •TO THE OWNER/OPERATOR/DEALER
REAR MOUNTED BLADE
Published 09/10OPERATOR’S MANUALPart No.00786977C
This Operator's Manual is an integral part of the safe operation of this machine and must be maintained with the unit at all times. READ, UNDERSTAND, andFOLLOW the Safety and Operation Instructions contained in this manual before operating the equipment.C01Cover
2501 Griffin Ave. Selma, AL 36703
© 2010 Alamo Group Inc.