Broilmaster SKSS2-1 User Manual
Thank you for choosing a Broilmaster Premium Gas Grill. This shelf kit has been designed to fit perfectly and function flawlessly – to provide years of service.
Please read the entire manual and compare the parts list to the parts provided with this kit before you begin the installation. If this shelf kit is missing any parts, contact your Broilmaster dealer. Keep this manual in a safe place to help you identify and order repair parts if they are ever required.
This manual covers the SKSS2 stationary shelf and the SKFPB2 and SKFB2 folding shelves. Refer to the illustration for your shelf, and follow the instructions carefully.
NOTE: These side shelves are designed to support approximately 25 pounds. Exceeding this weight limit may cause damage and void the warranty.
CAUTION: Parts may have sharp edges. Wear leather work gloves and handle parts carefully.
To order repair parts, contact your Broilmaster dealer. See the dealer locator at www.broilmaster.com.
When ordering parts, please have the following information available: Grill Model Number, Shelf Model
Number, Part Number and Description, and Quantity or Parts needed.
B076330 HEX HEAD BOLT
B073978 TRUSS HEAD SCREW
B076332 FLAT WASHER 9/32 ID X 5/8 OD
B076331 HEX NUT
B076333 LOCK WASHER 1/4 ID X 5/8 OD
B100770 PHILLIPS SCREW
B072217 PHILLIPS TRUSS HEAD SCREW
B076332 9/32 ID X 5/8 OD FLAT WASHER
B076333 1/4 ID X 5/8 OD LOCK WASHER
Stainless Steel Side Shelf
Attach the Handle Shelf Bracket to the grill using the Hex
Head Bolts, Flat Washers, Lock Washers, and Nuts. Do
Place the Tool Hook Bar inside the Shelf and place the
Shelf on the Bracket, aligning the screw hole. Insert the
Truss Head Screw and tighten. See Figure 1.
HANDLE SHELF BRACKET
Support Bracket Front - Stainless Steel
Support Bracket Front - Black
Support Bracket Back - Stainless Steel
Support Bracket - Back - Black
Bracket Attach Assembly
Shelf Support Stiffener
All repair part orders should be placed through your local Broilmaster® dealer. To locate a dealer in your area, contact Broilmaster Customer Service •www.broilmaster.com. To ensure prompt and accurate service, please provide the following information when placing a repair part order: Model Number of your grill, Part Name, Part Number, and Quantity of parts needed.
1.Remove the cooking grids, briquets and briquet rack from the grill.
2.Attach the Bracket Attach Assembly to the grill using the Truss Head Screws, Flat Washers, Lock Washers, and Nuts. See Figure 1. Note: Ensure that the Bracket Attach Assembly is installed so that the match light access hole is on the bottom. See Figure 2
3.Place the Side Shelf upside down on a clean surface and use the four
4.Place the support stiffener on the inside of the shelf using (2)
5.Hang the shelf brackets on the lower pins of the Bracket Attach Assembly. Tighten the four screws to secure the bracket arms to the shelf. See Figure 3.
6.To raise the shelf - swing it out and lift the notches over the upper pins. Make sure the shelf is securely in position before placing anything on it.
7.To lower the shelf - lift up on both brackets simultaneously and pull out slightly.
Correct Bracket Alignment
Incorrect Bracket Alignment
A Division of Empire Comfort Systems, Inc.
918 Freeburg Ave.
Belleville, Illinois 62220
Visit our web site at www.broilmaster.com
If you have a general question about our products, please
If you have a service or repair question, please contact your dealer.