Braun Flex Integral 5015
Type 5507
English
Use Instructions
Guarantee
Service Centers
6b
6a
6
5
4
3
2
• 0
1 2
|
0 |
3 |
1 |
|
|
|
2 |
|
3 |
•
7
8
1
English |
Our products are engineered to meet the highest |
|
standards of quality, functionality and design. We |
|
hope you thoroughly enjoy your new Braun |
|
appliance. |
|
|
Caution |
• Do not use the shaver near or over basins filled |
with water (e. g. bath tubs, showers etc.).
• Periodically check the cord for damages particularly at each end where the cord enters the plug.
• Replace the cord for safety reasons, if it is loose in the shaver socket 1.
• Do not wind the cord around the shaver.
This shaver is equipped with a pivoting head which has a triple shaving system with an integrated longhair cutter. The pivoting head swings to both sides and thus automatically adjusts itself to the contours of your face within its swinging angle. The triple shaving frame 6 with its twin foil F and the integrated longhair cutter f provide a permanent combination shave.
This means that the integrated longhair cutter cuts the longer hairs, while the twin foil F together with the cutterblock 5 under the foil, provide a close shave – all in one stroke.
•Wattage: 3 W.
•Voltage range:
100 - 240 V Q 50 / 60 Hz
(automatic adaption of voltage and frequency).
•This product conforms to the EMC-Requirements as laid down by the Council Directive 89/336/EEC.
2
1Shaver socket |
Description |
2Switch |
|
3Longhair trimmer |
|
4Cutterblock base |
|
5Duo cutterblock |
|
6Triple shaving fram |
|
FTwin foil |
|
fIntegrated longhair cutter |
|
7Foil protection cap |
|
8Button for releasing the triple shaving frame 6 |
|
Switch positions: |
Switch 2 |
0 = Off |
|
1= Shaving with the twin foil F and the integrated longhair cutter f
2= Shaving with the pivoting head locked at an angle to permit shaving under the nose or at the hairline
3= The longhair trimmer 3 is activated
• Connect the shaver to the mains. |
Shaving |
•Take off the foil protection cap 7.
•For shaving, push the switch 2 to setting «1».
•Hold the shaver at right angles (90°) to the skin.
•Stretch the skin with your free hand.
•Guide the shaver smoothly against the direction of beard growth, applying only gentle pressure.
The pivoting cutting system (twin foil F and integrated longhair cutter f follows the contours of your face automatically.
While shaving difficult parts of your face (e. g. under the nose or at the hairline), push switch 2 to setting «2», to lock the pivoting head at an angle.
3