4615
4605
TwinControl
Type 5100
Flex 4615
1
2
3
4
5
6
7
9
10
Flex 4605
3
2
585
585
585
|
|
off |
|
|
h |
|
|
s |
|
w |
a |
5 |
9 |
8 h |
|
|
|
11 |
8 |
on |
|
trim |
w |
a |
s |
h |
a |
b |
l |
e |
w |
a |
s |
h |
a |
b |
l |
e |
clean |
English
Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun shaver.
Technical specifications
Wattage via cord set: 4 W, automatic power supply 220-240 V~ / 50-60 Hz
on, the light comes on again, this indicates that the shaver is being recharged to maintain its full capacity.
•Model 4615 only: The red low charge light will come on when the battery capacity has dropped below 20%, provided the shaver is switched on. The remaining capacity will then be sufficient for 1 to 2 shaves.
Description
1Foil protection cap
2Shaver foil
3Cutter block
4Foil frame
5Release buttons
6Long hair trimmer
7Central switch
8Low charge light (4615 only)
9Charging light
10Shaver socket
11Mains adapter
Charging the shaver
•Via the adapter, connect the shaver to the mains with the motor switched off. Charge for at least 8 hours (transformer and shaver might get warm). Once the shaver is completely charged, shave until fully discharged. Then recharge to full capacity again.
•A full charge will give up to 25 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/dis-charging cycles.
•Best environmental temperature range for charging is 15°C to 35°C.
Indicator lights
•The green charging light shows that the shaver is being charged.When the rechargeable battery is fully charged, the charging light goes off. If later
Shaving
Turn on the shaver («on»)
Trimmer («trim»): When the long hair trimmer is activated, it allows the controlled trimming of moustache or sideburns.
Tips for the perfect shave
•We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.
•Hold the shaver at right angles (90°) to the skin. Stretch your skin and shave against the direction of beard growth.
•To ensure optimum shaving performance, we recommend to replace the shaver foil and cutter block every 18 months, or when the parts are worn.
Keeping your shaver in top shape
Cleaning under running water
After each shave, turn on the shaver and clean it under running hot water. Occasionally use soap (natural based liquid soap without particles and abrasive substances). Then rinse off all foam and let the shaver run for another moment.
Brush cleaning
Instead of cleaning under running water, you may clean your shaver with a dry
Loading...