GUIDE TO
SIMPLE
HOME THEATER
OPERATION
WITH YOUR
B & K SR10.1
SYSTEM REMOTE
Thank you for purchasing the B & K SR 10.1 System Remote Control!
Please use this manual as a guide to operating your home theater after the remote control is programmed by your dealer for automated operation.
The SR10.1 remote control is preprogrammed at the factory to operate the B & K component only. See your dealer for information on programming the SR10.1 remote control.
GUIDE TO SIMPLE HOME THEATER OPERATION
© 2002 B & K Components Ltd. All rights reserved.
B & K Components, Ltd. . 2100 Old Union Road . Buffalo, New York 14227 1.800.543.5252 In NY: 716.656.0026 Fax: 716.656.1291
E-mail: info@bkcomp.com . On the web: www.bkcomp.com
Table of Contents
Finding the MAIN Menu |
1 |
Turn On the System |
2 |
Using the MAIN Menu |
3 |
Select a New ACTIVITY |
3 |
Select a DEVICE Only |
4 |
Controlling the Volume |
5 |
Operating Any Device |
5 |
Using FAV - Favorites |
7 |
Backlighting |
9 |
Changing CONTRAST |
9 |
Batteries |
10 |
Cleaning the Screen |
10 |
Warranty |
12 |
Specifications |
12 |
1
Finding the MAIN Menu
The MAIN Button always takes you to the MAIN Menu.
The PAGE button switches between two MAIN Menu pages IF you have more than ten remote controls.
When the top title bar says MAIN, you are on the MAIN Menu.
PAGE 1
The lower title bar displays PAGE 1 or PAGE 2 as you switch. Each of the remote controls are represented by a button next to the corresponding screen label.
2
Turn On Your Entire System
Power on/off your entire system with the MAIN Menu by following these steps:
1. Touch the MAIN button to make sure that you are on the MAIN Menu. It doesn’t matter which page of the MAIN Menu is displayed.
2.Point the the remote control at the system (usually a repeating sensor near the screen).
3.Touch the On or Off button as desired. Hold the remote steady and pointed at the system until all components are correctly powered on or off. Turning on the system may take ten to twenty seconds.
4. If one component does not turn on/off, simply touch the button again.
TIP – Hold the remote control steady and pointed at the system until the 
indicator stops flashing.
Loading...