Barco GRAPHICS 500 R9002930 User Manual
Size:
6.88 Mb
Download

12. Display setup

Image 12-8

12.7 Sliderbox position

What can be done ?

The sliderbox can be displayed anywhere on the screen, the position can be set in this menu.

How to reposition the sliderbox?

1.Press MENU to activate the Tool bar

2.Press → to select the Display setup item

3.Press ↓ to Pull down the Display setup menu

4.Use ↑ or ↓ to select Sliderbox position (image 12-9)

5.Press ENTER

A sliderbox is displayed. Use the 4 arrow keys to drag the box to the desired position. (image 12-10)

Image 12-9

Image 12-10

There is a coarse and a fine adjustment of the position, use ENTER (when sliderbox is displayed) to switch between the two.

R5976367 BARCOIQ GRAPHICS 500 01/02/2007

 

111

12. Display setup

12.8 AutoImage Setup

What can be done ?

Autoimage allows to detect automatically the characteristics of the source (total pixels per line,...) and uses this information to adapt the image to the LCD panels.

Autoimage can adapt the image based on following data :

Total pixels per line

Start pixel

Phase

Contrast/brightness levels

Autoimage works only for data signals.

How to set up AutoImage?

1.Press MENU to activate the Tool bar

2.Press → to select the Display setup item

3.Press ↓ to Pull down the Display setup menu

4.Use ↑ or ↓ to select AutoImage setup (image 12-11)

5.Press ENTER

A dialog box is displayed. (image 12-12)

6.Use the arrow keys to select the desired item and press ENTER to activate or disactivate the item.

Image 12-11

Image 12-12

How to perform AutoImage ?

1.Press AutoImage on the RCU

A textbox showing a progress bar is displayed.

112

 

R5976367 BARCOIQ GRAPHICS 500 01/02/2007

12. Display setup

During the AUTOIMAGE measuring process the data source disappears temporarily (logo is displayed if background is set to logo )

12.9 Blanking

What can be done ?

The image can be blanked in several ways :

Top blanking

Bottom blanking

Left blanking

Right blanking

Image 12-13

Note that here the blanking is only done on the display i.e. the setting is not saved in the image file. in other words only one type of blanking (setting) can be done independently of the source.

How to blank the image ?

1.Press MENU to activate the Toolbar

2.Press → to select the Display setup item

3.Press ↓ to Pull down the menu

4.Use ↑ or ↓ to select Blanking (image 12-14)

5.Press ENTER

A slider box is displayed (image 12-15)

6.Use ←or →, the numeric keys on the remote, or the keypad to change the blanking.

R5976367 BARCOIQ GRAPHICS 500 01/02/2007

 

113

 

12. Display setup

Image 12-14

Image 12-15

Use the checkboxes to enable/disable the blanking Use the Reset key to reset the blanking values.

The logo is also affected by the blanking

114

 

R5976367 BARCOIQ GRAPHICS 500 01/02/2007