Barco 26-0503000-00 User Manual
Size:
991.7 Kb
Download

3. Installation

Power Installation

mçïÉê=fåëí~ää~íáçå

Use the following steps to install power to the MatrixPRO 8x8 DVI Router:

1.Connect an AC power cord to the AC Power Connector on the rear of the MatrixPRO 8x8 DVI Router, and then to an AC outlet.

2.Connect AC Power cords (or AC adapters) to all peripheral equipment, such as Ethernet Hubs and Encore Controllers. Please note:

~Connect each unit only to a properly rated supply circuit.

~Reliable grounding (earthing) of rack-mountedequipment should be maintained.

mзпЙк=`зкЗLiбеЙ=sздн~ЦЙ=pЙдЙЕнбзе

The MatrixPRO 8x8 DVI Router performs line voltage selection automatically. No user controls are required for line voltage selection. The AC power cords must be accessible so that the cords can be removed during field servicing.

Warning When the MatrixPRO 8x8 DVI Router is used in the230-voltmode, a UL listed line cord rated for 250 volts at 15 amps must be used. This cord will be fitted with a tandem prongtype plug.

Figure 3-1. TandemProng-typePlug

Avertissement La choix de la ligne de voltage se réalise automatiquement par le MatrixPRO 8x8 DVI Router Transformateur Graphique. On n'a pas besoin du controller usager pour la choix de la ligne de voltage.

Warnung Das MatrixPRO 8x8 DVI Router gerät mu beim Anschlu an 240V ~ mit einer vom VDE auf 250V/10A geprüften Netzleitung mit einem Schukostecker ausgestattet sein.

26

 

MatrixPRO • 8x8 DVI Router • User’s Guide