Axor 34316XX1 User Manual

Size:
1.45 Mb
Download

Installation Instructions / Warranty

Axor Citterio M

34316XX1

Axor Citterio M Wall-mountLavatory Faucet with Baseplate 34316XX1

Technical Information

Max. flow rate

.2 gpm

Max. water pressure

145 psi

Recommended water pressure

14.5 – 72 psi

Recommended hot water temp.

120°F – 140°F*

*Know and follow all applicable local plumbing codes when setting the temperature on your water heater.

Installation Considerations

Rough valve 10303181 must be installed. The finished wall must be installed and made watertight before installation of this trim kit.

For best function of this unit, the hot and cold supplies must be of equal pressure.

This faucet may be used with a continuous flow water heater as long as the flow pressure is at least 14.5 psi.

For best results, Hansgrohe recommends that this faucet be installed by a licensed professional plumber.

Turn the water off at the main before beginning installation.

Installation

Remove the covers.

Trim the plaster shields so that they extend 1/16” outside the surface of the finished wall

Seal the wall around the plaster shields with waterproof sealant.

Failure to seal the wall can lead to possible water damage.

Use a 17 mm deep socket wrench to remove the cartridges.

Install the new cartridges. The hot cartridge is marked with notches.

Push the extension spindle over the stem. Cut the extension spindle so that it extends 3/16” outside the surface of the finished wall.

Remove the plug from the spout port.

Thread the coupling over the stem. Cut the coupling so that it extends ¼” outside the surface of the finished wall.

For the spout: Measure the distance between the rough and the end of the plaster shield Record this measurement (“X”).

Add 1 ¾” to this measurement.

Cut the connecting thread so that it is X + 1 ¾” long.

Wrap the threads on the connecting thread with Teflon tape (1).

Use an 8 mm Allen wrench to install it in the rough (2).

Do not overtighten the connecting thread!

(3) Push the baseplate against the wall. Install the handle nuts, color rings, and handle fixing sets. Tighten the screws.

2

1

3

 

The connecting thread should extend 1 1/8” outside the surface of the finished wall.

Push the spout over the connector. Tighten the screw with a 2 mm Allen wrench.

Push the handles over the snap connectors.

In the off position, the handles should be horizontal.

If one of the handles is not horizontal, remove it (1), turn it slightly (2), and reinstall it (3).

2

3

1

User Instructions

Pivot the handle up to turn the water on. Pivot it down to turn the water off. In the “off” position, the handle is horizontal.

If the flow of water diminishes over time, use the spray former tool to remove the spray former.

Flush the spray former with clear water. Replace the spray former.

Replacement parts

 

 

 

 

 

 

11

 

 

 

 

 

 

 

 

 

 

 

13

12

7

 

 

 

 

 

 

 

 

 

10

 

 

 

 

11x2

 

 

 

 

 

 

 

 

33x1,5

 

1

 

6

 

 

 

 

 

 

 

 

 

 

 

5

 

 

M4x4

 

 

 

 

 

 

 

 

 

 

4

2

 

 

 

 

 

 

3

 

8

 

 

 

 

9

 

 

 

 

 

 

1

handle

34095XX0

 

 

 

 

2

color ring set

98927000

 

 

 

 

3

handle fixing set

98932000

 

 

 

 

4

nut

98929XX0

 

 

 

 

5

seal

97530000

 

 

 

 

6

fixing set

96393000

 

 

 

 

7

connecting thread

98933000

 

 

 

 

8

spray former

98926000

 

 

 

 

9

spout cpl. 225 mm

98935XX0

 

 

 

 

10

flange

98936000

 

 

 

 

11

hot cartridge

96350000

 

 

 

 

12

cold cartridge

96351000

 

 

 

 

13

spray former tool

98987000

 

 

 

 

XX = colors 00 = chrome

82 = brushed nickel

Cleaning Recommendation for Hansgrohe Products

Modern lavatory faucets, kitchen faucets, and showers consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain criteria when cleaning.

Cleaning Materials for Faucets and Showers

Acids are a necessary ingredient of cleaning materials for removing lime, however please pay attention to the following points when cleaning faucets and showers:

Only use cleaning materials which are explicitly intended for this type of application.

Never use cleaning materials which contain hydrochloric, formic, phosphoric, or acetic acid, as they cause considerable damage.

Never mix one cleaning material with another.

Never use cleaning materials or appliances with an abrasive effect, such as unsuitable cleaning powders, sponge pads, or micro fiber cloths.

Cleaning Instructions for Faucets and Showers

Please follow the cleaning material manufacturer’s instructions. In addition, pay attention to the following points:

Clean the faucets and showers as and when required

Use the amount of cleaning product and the amount of time recommended by the manufacturer. Do not leave the cleaner on the fixture longer than necessary.

Regular cleaning can prevent calcification.

When using spray cleaners, spray first onto a soft cloth or sponge. Never spray directly onto the faucet as droplets can enter openings and gaps and cause damage.

After cleaning, rinse thoroughly with clean water to remove any cleaner residue.

Important

Residues of liquid soaps, shampoos, and shower foams can also cause damage, so rinse with clean water after using. Please note: if the surface is already damaged, the effect of cleaning materials will cause further damage.

Components with damaged surfaces must be replaced or injury could result. Damage caused by improper treatment is not covered under the warranty.

Limited Lifetime Consumer Warranty

This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada.

WHO IS COVERED BY THE WARRANTY

This warranty extends to the original consumer purchaser only. This warranty is non-transferable.WHAT IS COVERED BY THE WARRANTY

This warranty covers only your Hansgrohe manufactured product. Hansgrohe warrants this product against defects in material or workmanship as follows: Hansgrohe will repair at no charge for parts only or, at its option, replace any product or part of the product that proves defective because of improper workmanship and/or material, under normal installation, use, service and maintenance. If Hansgrohe is unable to provide a replacement and repair is not practical or cannot be timely made, Hansgrohe may elect to refund the purchase price in exchange for the return of the product.

LENGTH OF WARRANTY

Replacement or repaired parts of products will be covered for the term of this warranty as stated in the following two sentences. If you are a consumer who purchased the product for use primarily for personal, family, or household purposes, this warranty extends for as long as you own the product and the home in which the product is originally installed. If you purchased the product for use primarily for any other purpose, including, without limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Hansgrohe and Commercial products, and (ii) for 5 years, with respect to AXOR products.

THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR:

A.Conditions, malfunctions or damage not resulting from defects in material or workmanship.

B.Conditions, malfunctions or damage resulting from (1) normal wear and tear, improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “norinse” cleaning products, or the use of the product in any manner contrary to the product instructions. (3) Conditions in the home such as excessive water pressure or corrosion.

C.Labor or other expenses for the disconnection, deinstallation, or return of the product for warranty service, or for installation or reinstallation of the product (including but not limited to proper packaging and shipping costs), or for installation or reinstallation of the product.

D.Accessories, connected materials and products, or related products not manufactured by Hansgrohe.

TO OBTAIN WARRANTY PARTS OR INFORMATION

Contact your Hansgrohe retailer, or contact Technical Service at:

Hansgrohe Inc.

1492 Bluegrass Lakes Parkway Alpharetta GA 30004 Toll-free(800)334-0455.

In requesting warranty service, you will need to provide

1.The sales receipt or other evidence of the date and place of purchase.

2.A description of the problem.

3.Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc. 1492 Bluegrass Lakes Parkway, Alpharetta, Georgia 30004, Attention: Technical Service, if required by Hansgrohe.

When warranty service is completed, any repaired or replacement product or part will be returned to you postage prepaid. EXCLUSIONS AND LIMITATIONS

REPAIR OR REPLACEMENT (OR, IN LIMITED CIRCUMSTANCES, REFUND OF THE PURCHASE PRICE) AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE REMEDY OF THE PURCHASER. HANSGROHE NEITHER ASSUMES NOR AUTHORIZES ANY PERSON TO CREATE FOR IT ANY OBLIGATION OR LIABILITY IN CONNECTION WITH THIS PRODUCT.

HANSGROHE SHALL NOT BE LIABLE TO PURCHASER OR ANY PERSON FOR ANY INCIDENTAL, SPECIAL, OR CONSEQUENTIAL DAMAGES, ARISING OUT OF BREACH OF THIS WARRANTY OR ANY IMPLIED WARRANTY (INCLUDING MERCHANTABILITY).

10