Audiovox 2269-1 User Manual

Size:
196.27 Kb
Download

NOTE:

THE NEW UNIVERSAL CONTROL SWITCH IS DESIGNED TO BE USED ON VEHICLES

 

WITH AN UPPER AND LOWER SHROUD.

I.REMOVE SCREWS FROM SHROUD AND SNAP OPEN. INSTALLER CAN BE CREATIVE IN LOCATING AREA FOR MouNT.NG. PICK A FAIRLY FLAT AREA. SWITCH CAN BE MOUNTED ON UPPER OR LOWER SHROUD.

2.CONTROL SWITCH MUST BE LOCATED IN THE AREA OF DRIVER'S CONVENIENCE AND NOT TO INTERFERE WITH WIRING AROUND STEERING COLUMN. MAKE SURE POSITION ALLOWS FOR KNEE CLEARANCE FOR CLUTCH OPERATION AND / OR BRAKE OPERATION .

3.DRILL 3/8" DIAMETER HOLE IN SHROUD. INSERT WIRE HARNESS THROUGH HOLE. INSERT THREADED END OF SWITCH THROUGH HOLE IN SHROUD. INSTALL LOCK WASHER AND NUT. SEE FIG 1.

4.POSITION CONTROL SWITCH ON SHROUD FOR DRIVER'S CONVENIENCE. TIGHTEN NUT.

5.ROUTE WIRES ALONG STEERING COLUMN TOWARDS THE BULKHEAD. REINSTALL THE SHROUD.

6.

INSTALL 4 PIN CONNECTOR ONTO CONTROL

SWITCH

WIRES. RED TO "R", BROWN TO

 

"B", GREEN TO "a" AND YELLOW TO "Y".

 

 

 

7.

THE CONTROL SWITCH CAN BE POSITIONED

AT ANY ANGLE DESIRED. FROM FUNCTION

 

END OF SWITCH, PUSH RUBBER BOOT TOWARD STEERING COLUMN. (THE UNIVERSAL

 

JOINT SET-UPIS USED FOR ANGLE ADJUSTMENT). AFTER DESIRED ANGLE IS

 

DETERMINED, TIGHTEN BOTH NUTS. REPLACE RUBBER BOOT TO ORIGINAL POSITION.

 

SEE FIG 2.

 

 

 

 

Ros tra

 

 

 

 

 

Inc. 1999

FORM# 2269

 

Certified Q8 9000/180

9001

 

REv-A

 

 

 

 

Made in the u .8.A.

07/99

4- PIN CONNECTOR

I

:>

 

 

 

 

 

r--'l

--===1

 

 

 

-I

 

 

 

=-=~

---

 

 

=-:.=3

I.

9

UIc-

 

 

 

 

~

SHROUD

(UPPER OR LOWER)

ANGLE ADJUSTMENT BOOT

<:: I

,

FIGURE 2

~I

, BOOT

~