TA-TM 5Series |
|
|
|
15G067224000 |
Screwless Model |
|
All Rights Reserved. |
|
|
|
Copyright © 2005 ASUSTeK COMPUTER INC. |
Installing the power supply unit (PSU)
1 |
2 |
Locate the PSU slot. |
Slide the PSU into the slot |
|
until it snugly fits the |
|
metal rail. |
3 |
|
Secure with screws.
Installing a floppy disk drive (FDD)
1 |
2 |
Using a screwdriver, push |
Insert the FDD into the bay. |
the knock-down metal |
Make sure the FDD holes |
cover in and out of the |
align with the chassis holes. |
chassis until it is removed. |
|
3 |
4 |
Secure the FDD with |
Release the lock tabs on the |
screws. |
front bezel to disengage the |
|
drive cover. |
Removing the side cover and front bezel
1 |
2 |
Remove the screws on |
Push the side cover towards |
the rear panel. |
the rear panel. |
Installing an optical disk drive (ODD)
1 |
2 |
Push the bay lock upward. Insert the ODD into the bay.
3 |
4 |
Align the ODD holes with |
Release the lock tabs on |
the bay holes, then push |
the front bezel to |
down the bay lock to |
disengage the drive cover. |
secure the ODD. |
|
Installing an expansion card
1 |
2 |
Choose the slot that you |
Align the card connector |
|
want to use. Push to |
with the slot, then press |
|
unlock the lock tab. |
firmly until the card is |
|
Remove the metal cover |
completely seated on the |
|
opposite the slot that you |
slot. |
|
want to use. |
|
|
|
|
|
3 |
|
4 |
|
|
|
Photo shows the card |
Push the expansion card |
seated on the slot. |
lock on the rear panel to |
|
secure the slot. |
E2070
3 |
4 |
Release the side |
Swing the front bezel in the |
|
tabs that secure |
direction of the arrow. |
|
the front bezel to |
Unhook the hinge-like tabs. Set the |
|
the chassis. |
||
front bezel aside. |
||
|
Installing a hard disk drive (HDD)
1 |
2 |
3 |
1. Push the bay lock |
|
upward. |
||
|
2. Insert the HDD into the bay.
3. Align the HDD holes with the bay holes, then push down the bay lock to secure the HDD.
Reinstalling the side cover and front bezel
Hook the hinge-like |
1 |
tabs to the holes on |
|
the chassis. Swing |
|
the front bezel in the |
|
direction of the |
|
arrow and push to |
|
secure the front |
|
bezel to the chassis. |
|
|
|
2 |
3 |
|
Push the side cover towards
the front bezel.
Drive screws on the rear panel.
TA/TM 5 Series